Installation Instruction for the Jazz1000/1100 the 3300 the ArcticChill88/98 theArcticStar55 and the AquaPoint60 WaterCoolersCaution• When installing a POU Cooler use only new hoses (supplied) and new compression fittingswhen connecting to the mains.• J Guest push fit connections should be regularly checked for leakage. Over time they willbecome brittle and need to be replaced.• If the electrical cord is damaged, it must be replaced by a competent and qualifiedindividual.• Children, and persons with reduced physical or mental capability must be instructed andsupervised on the use of the equipment.• Any maintenance, servicing and moving of the equipment must only be undertaken by aqualified and trained individual.• It is strongly recommended that the mains water supply to the POU Cooler is turned offover week ends and long periods of office closures.• Please note: Product warranty is ONLY valid if the product installation has been carried outaccording to our Installation Instructions and conditions stated on our Terms andConditions.Safe Usage• Always turn electricity off before working on the equipment• (POU)Always turn water off at nearest stop cook before working on the equipment• (Bottled Water) Remove the bottle• When not in use for an extended period: Turn mains water off or remove bottle. Turnpower off. Sanitise before re-commissioning.• Install cooler on a flat surface to avoid vibration and noise• Leave 15cm gap all around to provide good ventilation• Install away from heat source which could affect the unit's cooling capacity• Avoid freezing conditions which could rupture the pipes• Never tilt unit over 45 degrees when carrying to storing• Wait for an hour after transport before installing to allow coolant to settle• Fill water reservoir with water before unit is powered up to avoid damage to therefrigeration and heating elementCommissioning• For POU Coolers follow the Plumbing & Filter Installation Instructions• For conversion from Bottled to POU follow the Conversion Instructions• Sanitise the cooler before first use and follow Sanitising Instructions• For “Open Tank” Coolers make sure that the water detaching board (Baffle) inside the cold-water tank is inserted tightly. If not fixed properly, it may affect your cold-water volume• For POU Coolers ensure that the float, connected to the water tank lid, moves freely• For Direct Chill Coolers follow Direct Chill Cooler instructions• Before switching the power on make sure that both the cold and hot water tanks are filledwith water