AAL Homecare Profiline HC-140 Instruction Manual
INSTRUCTION MANUALAAL Profiline TransmitterHC-125-BA V0.01 Armbandsender Seite 1 von 4HC-140-BA-EN V1.02 Transmitter page 1 of 4AAL Homecare Fon +49 (0) 2208 9339170 Fax +49 (0) 2208 9339063 www.aal-homecare.comWarningThe use of a call device does not release supervisors from the obligation to supervise the personssupported by such a device. This system is radio-based and must therefore not be used for monitoringpurposes if life-threatening conditions are foreseeable.Package contents HC-140Product variants Bestellnummer1 Frequenz1AAL Profiline hand transmitter with wristband HC-125 869,23 MHzAAL Profiline hand transmitter with necklace HC-135 869,23 MHzAAL Profiline multi-propose transmitter with wristband and necklace HC-145 869,23 MHzBedienungsanleigung HC-140-BA-EN1Order number and 2frequency can be found on the identification decal.While unpacking, each shipment should be inspected for completeness and damage.Note: In this instruction manual, the “AAL Profiline hand transmitter and multi-purpose” is referred to as “handtransmitter”.Fig.1: Hand transmitterPutting into operationThe hand transmitter is supplied ready for operation with battery. Initial putting into operation only requiresprogramming to the desired AAL Profiline receiver and checking the radio range in the operating environment.Triggering a callA radio call is triggered by pressing the red actuating area. This is indicated by illumination of the red call LED belowthe cover. The LED messages are listed in the enclosure, table 1.Programming / deleting the hand held transmitter to / from a radio receiverThe “programming” to the radio receiver required for initial putting into operation and the “deletion“ from the radioreceiver that may be required if the transmitter is ported to another radio receiver can be found in the instructionmanual of the respective radio receiver.Range of the radio linkThe range meets the requirements of the technical inspection body of the German health insurance funds. Withinbuildings, a range of approx. 30 m can be expected. However, the range depends to a large extent on the localconditions.Checking the range at the usage siteBefore using the transmitter for the first time, an interference-free operation of the radio link has to be ensured.Proceed as follows:1. Switch on all electronic entertainment and communication devices (e.g., television sets, game consoles, andcomputers) in the immediate environment.2. Check if the radio message is received by the radio receiver at a distance exceeding the intended usagedistance by approx. 5 to 10 m. Ensure that the message is trigged by a single call triggering!Important: Repeat the check if the positions of electronic devices are changed or new electronic devices are put intooperation in the immediate environment of the usage site.Actuating area Call LED (red) |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine