AAMP Global PAC AP4-TY13 R.2 Manual
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.PAC-audio.comPacific Accessory CorporationPage 1Rev: 4Date:02022021Advanced Amplifier Interfacefor Select Toyota and Lexus ApplicationsAP4-TY13 R.2The AP4-TY13 R.2 provides a 6-channel pre-amp output for use with aftermarket audio equipment. Using the fullrange, fixed level head unit output, in conjunction with data bus messages, the AP4-TY13 R.2 delivers a variable5v RMS pre-amp output with fading, balance, equalization, and level control capabilities. The module also retainsaudio from other vehicle features such as factory navigation prompts, Bluetooth and Voice Activation. An accessorycontrolled remote amplifier turn on wire is also provided by the AP4-TY13 R.2. When used in conjunction with theAPA-TOS1 (sold separately), the module can provide a variable 2-channel fiber optic digital audio output (TOSLINK).Introduction and FeaturesImportant Notes1. Toyota Safety Connect (SOS) can easily be retained. See the page 3 for detailed instructions.2. The factory radio's speed controlled volume, DSP, and surround sound mode are not supported by the AP4 outputs.3. The factory amplifier must remain connected, and in the vehicle after the AmpPRO has been installed.4. Prior to testing, cycle the ignition off and back on again to properly initialize the AP4-TY13.5. The radio's beep setting must be enabled on the factory radio in order to hear the audible tones when making selectionsthrough the radio.6. Initially, if the beep through the AP4-TY13 does not match the on / off selection through the radio, cycle the beep to theopposite setting and back, then test again.7. The radio's beep volume and minimum volume levels are set to 0 dB by default. If you are happy with this level in yourparticular application, additional adjustment is not required. Please refer to the Setup and Configuration section on page 4for more details.8. The Radio's Nav / VR Voice, incoming E-mail tone, Ringtone, In-Call, Incoming SMS / MMS tone and Incoming SMS Voicevolumes can be adjusted through the radio's settings menu as they were prior to installation of the AP4-TY13.9. The remote output is rated at 2A of current. If more current is needed, an external relay must be used.10. Channels 5 and 6 are non-fading outputs. The output level of channels 5 and 6 can be controlled using the supplied levelcontrol knob.Wiring Connection ChartTo AftermarketAmplifierNon-FadingRearFront1(L) 2(R) 4(R) 5(L) 6(R)3(L)Remote Turn On Output2A Max OutputNon-FadingLevel ControlKnobRemote Turn On Output (2A Max)SOS Mute ( - Trigger Input )GRAY GRAYBLACK BLACK28-pin10-pin |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine