AARCOMM PNUT Quick Start Manual
PNUT REMOTE CONTROL SYSTEMThe PNUT remote control system contains thefollowing items:• H212 handheld• C220 controller• Antenna• Charging cradle• Wiring harnessPOWERING ON THE HANDHELDThe H212 requires a special sequence to turn on.This sequence is used to verify that all the buttons areworking correctly prior to start up. It also minimizesany accidental powering up of the handheld.To power up the H212:1. Press and hold the red button.2. Press and hold the green button.3. Release the red button.4. Release the green button.Regular flashing green LED: System turned on butno link.Solid, or short flashes of green LED: System turnedon and linked.MATCHINGFirst Method1. Turn off the H212.2. Apply power to the C220.3. Momentarily (“blip”) the power off to the C220six to seven times (i.e. power off for 1/2 second,power on for one second; six times). Leave thepower on after the sixth blip.4. The LED on the C220 will light up dark blue.5. Continue with steps five to eight below in secondmethod.Second Method1. Turn off the H212.2. Apply power to the C220.3. Using a smooth motion, wave the H212 backand forth over the top left corner of the C220 sothat the two magnets under the red and greenbutton pass over the surface of the Aarcommlogo.Or4. If the C220 successfully detects the magnets onthe H212, the C220 LED will light up dark blue.5. Press and hold the three round buttons on thebottom left side of the H212.6. Press and release the red button on the H2127. The C220 LED will turn white and a messagewill appear on the H212 indicating a successfulmatch. If not, make sure the H212 and the C220have compatible part numbers.8. Power on the H212 normally to verify that thesystem is matched.POWERING OFF THE HANDHELDPressing the red E-stop button will shut down theH212 handheld. The LCDs on the H212 will be putinto in sleep mode and will not draw any power fromthe battery.CHARGING THE BATTERYThe H212 is waterproof and completely sealedto IP67 rating. For improved reliability, it does nothave a removable battery and is charged using thewireless charging cradle. The magnets on the backof the H212 are only used for alignment and not forelectrical contact.The red LED will begin to flash when the H212 shouldbe charged. Place the H212 on the charging cradle tobegin charging. The LCD screen will show the chargestatus; please allow a minute or two for the chargelevel to be calculated accurately.A battery that is completely discharged will takeapproximately three hours to charge. The battery canbe charged at anytime even if it is not depleted. A quick30 minute charge will allow the handheld to operatefor eight hours. A full battery will last approximately 50to 120 hours, depending on the performance setting.1324Model: C220STATUSModel: C220STATUSModel: C220STATUS On 1 second1/2 second |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine