Stand 03_20081 = handle unit2 = column3 = turning gear4 = locking knob on the column5 = power unit6 = running wheels7 = locking bolt on the turning deviceThis turning device is for the most part already prepared to be mounted by themanufacturer. Should this not be the case, please attach the turning device asfollows:1. Open the locking bolt on the column and remove the handle unit.2. Slide the turning device upward on the column until it locks at the upperlocking point (1).Attention: the turning device must be in this position any time you are climbingup or down stairs!3. Now put the handle unit with the attached turning device back onto thepower unit and lock the column with the locking knob. Make sure that thelocking knob is tight.4. As soon as the handle unit is well attached to the power unit and the turningdevice is locked in the upper position, you may turn on the s-max. Press theUp/Down switch, direction “up”, until the running wheels are approximately2-3 cm in the air.1212345766Operator’s manualTurning device s-max