ABB ACS 400 Installation Manual

Also see for ACS 400: User guide User manual User manual User manual

Contents

installation guide

ABB ACS 400 Installation Manual Manual pdf 1 page image

Installation GuideBefore Starting InstallationCHECK BOX CONTENTS: ACS 400, Manual, Mounting Template, Installation Guide, Clamp platesCHECK INSTALLATION SITE: See Manual.TOOLS NEEDED: Screwdrivers, Wire stripper, Tape measure, 4 pcs 5x12 mm screws, DrillFROM MOTOR NAMEPLATE: Supply voltage, Nominal motor current, Nominal frequency, Nominalspeed, Nominal power, Cos ϕNote! This Installation Guide is only for setting the speed of a single motor.ENSURE MAINS SUPPLY TO INSTALLATION IS OFF.ENSURE MOTOR IS SUITABLE FOR USE WITH ACS 400.ACS 400 MUST BE INSTALLED BY A COMPETENT PERSON.IF IN DOUBT DO NOT INSTALL.Packing box lid contains wall mounting template.Remove it from the box.12ACS 400 should ONLY be mounted vertically on asmooth, solid surface, free from heat, damp andcondensation. Ensure minimum air flow gaps of 200 mmabove and below and 50 mm around sides of unit.1. Using mounting template, mark fixing hole positions.2. Drill the holes.3. Screw in four screws or affix nuts and bolts(depending on mounting surface).3Position ACS 400 onto fixings and securely tighten inall four corners.Note! Lift ACS 400 by its chassis and not by its cover.for product type ACS 400

/ 4

Related manuals for ABB ACS 400