—ABB INDUSTRIAL DRIVESACS800-01 drives (0.55 to 200 kW)ACS800-U1 drives (0.75 to 200 hp)Hardware manual

ABB ACS800-U1 Hardware Manual

ACS800 Single Drive Manuals

What this chapter contains

Installation and maintenance work

Grounding

Mechanical installation and maintenance

Printed circuit boards

Operation

Permanent magnet motor

Installation and commissioning flowchart

Product and service inquiries

Type code

Main circuit and control

Unpacking the unit

Delivery check

Free space around the unit

Mounting the drive on the wall

Cabinet installation

Unit above another

Protecting the motor insulation and bearings

Requirements table

Permanent magnet synchronous motor

Supply connection

Thermal overload and short-circuit protection

Protection against short-circuit inside the drive or in the supply cable

Ground fault protection

Selecting the power cables

Alternative power cable types

Additional US requirements

Equipment connected to the motor cable

Protecting the relay output contacts and attenuating disturbances in case of inductive loads

Selecting the control cables

Connection of a motor temperature sensor to the drive I/O

Control cable ducts

Checking the insulation of the assembly

Connecting the power cables

Conductor stripping lengths

Wall installed units (US version)

Warning sticker

Frame size R5

Frame size R6

Connecting the control cables

degrees grounding

Cabling of I/O and fieldbus modules

Fastening the control cables and covers

Circuit diagram

Dimensional drawing

AGPS-11C board specifications

External control connections (non-US)

External control connections (US)

RMIO board specifications

Relay outputs

Checklist

Heatsink

Fan replacement (R4)

Fan replacement (R5)

Fan replacement (R6)

Replacement (R4, R5)

LEDs

Symbols

Derating

Frame sizes R5 and R6

Fuse tables for frame sizes R5 and R6

Ultrarapid (aR) fuses

Quick guide for selecting between gG and aR fuses

Cable types

Cable entries

NEMA data

Fuses

Input power connection

Cooling

Materials

CE marking

Second environment (drive of category C3)

C-tick" marking

UL/CSA markings

Frame size R2 (IP 21, UL type

Frame size R6 (IP 21, UL type 1), -205-3 and -255-5 units

Dimensional drawings (USA)

Selecting the correct drive/chopper/resistor combination

Resistor installation and wiring

ACS800-01

Fibre optic cables

Inquiries

Circuit breakers

Prevention of Unexpected Start

Replacement (R6)

Sizing

Mains cable fuses

Dimensions, weights and noise

Efficiency

Ambient conditions

Second environment

US tables

Dimensions and weights

Dimensional drawings

Frame size R2 (IP 21, UL type 1)

Frame size R2 (IP 55, UL type 12)

Frame size R3 (IP 21, UL type 1)

Frame size R3 (IP 55, UL type 12)

Frame size R4 (IP 21, UL type 1)

Frame size R4 (IP 55, UL type 12)

Frame size R5 (IP 21, UL type 1)

Frame size R5 (IP 55, UL type 12)

Frame size R6 (IP 21, UL type 1)

Frame size R6 (IP 55, UL type 12)

Optional brake chopper and resistor(s) for the ACS800-01/U1

ACS800-07/U7

ACS800-U1