910—Quick Start GuideARG600/ARR600 Wireless Gateway1 LAN port(s)2 SIM card slot(s)3 Console/serial port4 DIP switches5 Application serial port (RS2)6 Antenna connector FME (male)7 Power switch8 Power supply 12...36 VDC13 542 7681 I/O connector (only ARR600 models)2 Power supply 12...48 VDC3 Console/serial port4 Power switch5 Console/serial port switch6 DIP switches7 Application serial port (RS2)8 LAN port(s)9 Antenna connector SMA (female)10 SIM card slot(s)13542 768

getting started

ABB ARG600 Quick Start Manual

safety information

Section 1 Introduction

Document conventions

Section 2 ARG600 overview

Physical interfaces

ethernet lan

Back panel

power supply connector

DIN rail mounting

Section 3 Getting started

User interface

Setting Ethernet port function to LAN

Section 4 Network configuration

Setting WAN failover and backup routing

Configuring the network monitor

Configuring DNS proxy

Section 5 Serial port configuration

Section 6 Additional system configuration

Restoring factory default settings

Section 7 Service configuration

service configuration

Section 8 IEC-104 application settings

Section 9 Modbus application settings

Configuring Modbus modes

Configuring the network master to serial slaves mode

Common parameters

Route parameters

Modbus route settings

Section 10 Troubleshooting

Section 11 Technical data

technical data

Section 12 Glossary

ARG600 ANSI

quick start guide

Description

Application

Communication

Technical data

Mounting

Tools

Document revision history

References

section 1 introduction

document conventions

physical interfaces

dip switches

ethernet connector

side panel

din rail mounting

user interface

configuring the default route

Configuring the mobile WAN interface

routing parameters

serial port configuration

additional system configuration

restoring factory default settings

troubleshooting

Viewing the system log

Section 9 Technical data

Section 10 Glossary

ARR600