AX400 Series User GuideModels AX460 and AX466Single and Dual Input pH/Redox(ORP) Analyzers7.00Monitoring pH7.00 pHpH7.00Monitoring pH7.00pHpH

ABB AX400 Series User Manual

electrical safety

INTRODUCTION

Direct Acting (Acid Single PID Control

Ouput Assignment

OPERATION

Operating

Dual (Bi-directional) PI Controller

OPERATOR VIEWS

PROGRAMMING

Configure Control

Configure Single PID Controller

Configure Dual (Bi-directional PI Controller

Configure Power Failure Recovery Mode

AnalyzeIT AX460

Dual Input pH

Single Input Redox (ORP)

Dual Input Redox (ORP)

Dual Input pH and Redox (ORP)

Wash Function

View Outputs

View Software

View Logbook

View Clock

SETUP

Set Up User Defined Buffers (pH Only)

Adjust Offset (Redox/ORP Only)

Automatic, Single- and Two-Point Calibration (pH Only)

Manual, Single- and Two-Point Calibration (pH Only)

Grab Calibration (pH Only)

Configure Display

Configure Sensors

Configure Diagnostics

Configure Alarms

Configure Outputs

Configure Clock

Configure Security

Test Outputs and Maintenance

INSTALLATION

Mounting

Panel-mount Analyzers

Connections, General

Relay Contact Protection and Interference Suppression

Cable Entry Knockouts Wall-/Pipe-mount Analyzer

Wall-/Pipe-mount Analyzer Connections

Connections

Panel-mount Analyzer Connections

pH Sensor Systems Connections

CALIBRATION

factory settings

SIMPLE FAULT FINDING

SPECIFICATION

APPENDIX A

Introduction

Operation

Operator Views

Setup

Programming

IM/AX4PH Rev. P

Installation

Calibration

Factory Settings

Simple Fault Finding

Checking the Temperature Input

Specification

Appendix A – Buffer Solutions

AX400 Series

AX410

AX411

AX416

AX450

AX455

AX466