ABB CBT-STAT Installation And Wiring

ABB CBT-STAT Installation And Wiring Manual pdf 1 page image

—INSTALLATION AND WIRINGBDS0009 rev 14CBT-STAT, CBT-STAT-H©ABB 2021 All Rights Reserved.Subject to change without notice 1BDS0009 rev 14MOUNTING• Install the CBT-STAT or CBT-STAT-H on an easily accessibleinterior wall, approximately 60” (1.5 m) above the floor in an areaof average temperature• Avoid direct sunlight or other heat sources (e.g. the area aboveradiators or other heat-emitting equipment)• Avoid locations behind doors, on outside walls and above orbelow air discharge grills and diffusersIMPORTANT NOTICE AND SAFETY ADVICEThis device is for use as an operating control. It is NOT a safety device.Where a device failure endangers human life and/or property, it is theresponsibility of the client, installer and system designer to add additionalsafety devices to prevent a system failure caused by such a device failure.Ignoring specifications and local regulations may cause equipment damageand endangers life and property. Tampering with the device ormisapplication will void warranty.INSTALLATION1. Connect the CB Line field controller to the terminals ofthe power case according to the wiring diagram.2. Attach the mounting plate to the flush-mounting box.Make sure that the nipple with the front-holding screw isfacing to the ground. Make sure the mounting screwheads do not stand out more than 0.2” (5 mm) off thesurface of the mounting plate.3. Slide the two latches located on the top of the front partinto the hooks at the upper side of the mounting plate.4. Carefully lower the front part and continue pressinggently until the front part is fully connected.5. With a Phillips-type screwdriver (size #2), carefully tightenthe front holding screw to secure the front part to themounting plate. This screw is located on the front lower-side of the unit.

/ 2

Related manuals for ABB CBT-STAT