ABB MUL1-R1 Installation Instructions Manual

Also see for ACS150 series: User manual User manual User manual User manual Installation instructions

ABB MUL1-R1 Installation Instructions Manual Manual pdf 1 page image

ACS150 and ACS350MUL1-R1 Installation instructions© 2006 ABB Oy. All Rights Reserved. 3AFE68642868 Rev. D / 03.03.20062. Fasten the gland box frame to wall with four M4 screws(not included).1. Fasten the gland box frame to drive with two M4◊12screws.12WARNING! Before installing MUL1-R1option, read the safety instructions andmechanical and electrical installationinstructions in the drive userís manual.Follow the instructions when installing,operating and servicing the drive. Ifignored, physical injury or death mayfollow, or damage may occur to thedrive, motor or driven equipment.6474. With FPBA-01 or FCAN-01 option modules, remove thedetachable lid (4) from the gland box cover.5, 6, 7. With any fieldbus option module except FRSA-00,remove the support plate (5), install the I/O clamping plate(6) and the option grounding plate (7) to the gland boxframe. See Mechanical installation in the drive manual.3a3. Install clamps (3a) for control cables (see power cablelead-throughs), or if cables are run in conduits, replace allclamps with suitable glands (not included). Run cablesthrough the clamps and tighten. Strip cable ends. Fastenthe grounding conductor (PE) of the input power cable andthe twisted shield of motor cable under the groundingclamps (3b). Connect the conductors to appropriateterminals. See Electrical installation in the drive manual.3b5

/ 4

Related manuals for ABB ACS150 series