Connectivity Packages forREF 541/543/545,REM 543/545,RET 541/543/545Userís Guide

About this manual

Use of symbols

Document conventions

Terminology

Abbreviations

Installation and uninstallation

Uninstalling connectivity packages

Connectivity Package Manager

Associating connectivity package versions

Adding connectivity packages

Content and usage of connectivity packages

Logical node naming

ABB REF 541 User Manual

REM 543

Safety information

Introduction

Instructions

Requirements

Configuration

Technical Description

Measurement functions

Condition monitoring functions

Standard functions

Machine terminal configuration

MIMIC configuration

LON network configuration

Modbus configuration

External parameterization

Power supply versions

Low auxiliary voltage indication

Analog channels

unit for analog channel

Technical data of the measuring devices

Calculated analog channels

Filter time of a digital input

Pulse counters

Oscillation suppression

Digital outputs

Single-pole power outputs (PO)

Signal outputs (SO)

RTD/analog inputs

Transducer supervision

Transducer connections

Attributes of an RTD/analog input for machine terminal configuration

RTD/analog input configuration example

Calibration

RTD temperature vs. resistance

Analog outputs

Analog output configuration example

Trip circuit supervision

Configuring the trip circuit supervision CMTCS

Self-supervision (IRF)

Serial communication

LON/SPA bus communication on the rear connector X3.3

Parallel communication support

System structure

LON inputs and outputs via a LON bus

Display panel (HMI)

Alarm LED indicators

Non-latched alarm

Latched alarm, steady LED

Interlocking

Design description

Terminal diagram of REM 543

Terminal diagram of REM 545

Terminal diagram of the RTD/analog module

Terminal connections

Service

Ordering Information

Hardware versions of REM 543 and REM 545

Revision History of REM 54

Configuration, setting and SA system tools

Index

REF 541

REF 543

REF 545

REM 545

RET 541

RET 543

RET 545


Contents Table Of Contents About this manual Use of symbols Document conventions Terminology Abbreviations Installation and uninstallation Uninstalling connectivity packages Connectivity Package Manager Associating connectivity package versions Adding connectivity packages Content and usage of connectivity packages Logical node naming	Connectivity Packages forREF 541/543/545,REM 543/545,RET 541/543/545Userís Guide Next / 36