ABB TZID-C Quick Start Manual

Also see for TZIDC: Operating instructions Commissioning instructions Operating instructions Commissioning Instruction Manual

ABB TZID-C Quick Start Manual Manual pdf 1 page image

QUICK-STARTBrief Operating Instructions for TZID-C With Software Rev. 1.1 and LowerCommissioning1. Turn on the air supply to the positioner.2. Apply the 4...20 mA analog input signal to the positioner.3. Check for proper mounting: refer to instruction manual if needed.• Open front dust cover from positioner to access the local control keys.• Press and hold MODE.• Additionally briefly press or until mode 1.3 MAN_SENS is displayed.• Release MODE.• Press or to move the actuator to its mechanical limit stops in both directions, and note the values.The angle of rotation on the display is indicated in degrees. Recommended positions of limit stops:> -28° and < +28° for linear actuators> -57° and < +57° for rotary actuators• Adjust the mounting position of the positioner in relation to the actuator if required.Configuration4. Switch to the configuration level:• Press and hold or simultaneously.• Additionally briefly press ENTER.• Wait until the countdown from 3 to 0 is completed.• Release or .The device will automatically go to program level “P1.0”5. Select the actuator type “ROTARY” or “LINEAR” using or .Note: This Step must be done prior to Autoadjust (Step 6)TZID-CValve PositionerPN25087Copyright 2004 ABB. All Rights Reserved [February, 2004]

/ 3

Related manuals for ABB TZIDC