ABBREE AR-M6 Instruction Manual
1.FUNCTIONS & FEATURES2.PRECAUTIOMS3.KNOW ABOUT THIS RADIO 4.HOW TO USE THIS RADIO2.1 You are adviced to check radio version first before connect power cable:◆12V version radio: Your radio must be supplied with a continued currentof 12 volts.2.2 Please install the antenna (connect to the location“B”on the back panelof the radio) and set the SWR (Standing Wave Ratio) before transmitting.Failure to do so may result in destruction of the power amplifier, which isnot covered by the guarantee.◆AM and FM mode◆ VOX◆ CTCSS/DCS◆ VOX◆ SQ and ASQ Control◆ Full Channel SCAN◆ EMG Channel CH9/191 2 34.1 Power On/Off the Radio ....................................................................(1) Turn VOL knob clockwise to power on the radio, the LCD displayschannel number.(2) Turn VOL knob anti-clockwise, until hear "Ka Ta", the radio ispowered off.4.2 Volume Control ...................................................................................Turn VOL knob clockwise to increase volume, anti-clockwise to decreasevolume.4.3 ASQ / SQ Control ...............................................................................※ASQ (Automatic Squelch Control)Turn SQ knob anti-clockwise into ASQ position. LCD displays " ". Norepetitive manual adjustment and a permanent improvement between thesensitivity and the listening comfort when ASQ is active. This function canbe disconnected by turning the switch clockwise. In this case the squelchadjustment becomes manual again. " " disappears from LCD.※SQ (Manual squelch)Turn the SQ knob clockwise to the exact point where all backgroundnoises disappear. This adjustment should be done with precision as, if setto maximum (fully clockwise), only the strongest signals will be received.4.4 ▼CH/▲CH ...........................................................................................※Channel Selector (short press)(1) These keys allow increasing or decreasing a channel. A beep soundseach time the channel changes.(2) Hold or can fast change working channel.※Scan (very long press)(1) Press and hold the or key for 7 seconds or until a beep soundsto start scan function, LCD displays " ".(2) Short press or key to change scan direction during scan.(3) Short press or [PTT] key to exit scan function.3.1 Function locationCB RADIOInstruction Manual1453 7 6 8 10 9CBDA21 POWER ON/OFF ~ VOLUME CONTROL2 SQUELCH~ASQ (Automatic Squelch Control)3 MICROPHONE JACK4 LCD5 MODE ~ KEYPAD LOCK6 CTCSS/DCS ~ CTCSS/DCS SET7 EMERGENCY CHANNEL ~ RESET8 CHANNEL SELECTOR9 CHANNEL SELECTOR10 VOX ~ VOX SETA ANTENNA JACKB EXTERNAL SPEAKER JACKC POWER CONNECTIOND PTT SWITCHRAR-M6 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine