Absco Industries Assembly Instruction ManualABSCO AWNINGMODEL: AWN333.00mW x 3.00mD x 3.00mHModel: AWN33 15/11/191AU: 1800 029 701NZ: 0800 466 444admin@absco.com.auwww.abscosheds.com.auBuilding approval:Local authority approval must be obtained prior to construction. Once you have selected your site, draw a siteplan and lodge your application together with a copy of the engineering plans located at the back of theseinstructions.Assembly:The frame is constructed from 80mm x 40mm galvanized steel channel, similar to that used in domestic steelhouse framing. All sections are cut to exact lengths, with channel ends pre-punched where necessary to simplifyassembly. If classic cream color channel is supplied, remove the protective plastic coating after assembly.Channel sections are secured together using 10G x 16mm self drilling tek screws. (Supplied). Roof sheets aresecured to the frame using 10G x 16mm self drilling tek screws with neoprene washers (supplied). Barge cappingis secured together using 3mm pop rivets (supplied).Construction:The patio frame can be easily connected to brick or blockwork, using M10 x 75 dynabolts or coach screws, (notsupplied) through the rear beam of the frame. If fixing the frame to existing steel/timber fascia, the fascia tohouse connection points may require additional strengthening to support the patio frame. Refer to the attachedengineered drawings 06205-003-AW02 & 06205-003-AW05 for further details.If you are attaching the patio frame to materials or structures other than those noted above, you should seekindependent engineering advice on how to do so.Concrete slab or footingsThe frame must be secured to a concrete slab or footings, details of which are noted on the attached engineereddrawings. Brackets and dynabolts for securing the frame to either a concrete slab or footings are included inthis kit.Length: 3.0mDepth 3.0mHeight: Variable to 3.0mWind Rating: W50C (C2)Slab Size: 3180 x 2910mm3180mm2910mm