GLASS BREAK DETECTORINSTRUCTIONFEATURE: Double detecting method SMD technology Pulse width adjustable Sensitivity adjustable convenient mountingMOUTING THE DETECTOR1. SELECT LOCATION Choose a location in front of the protectedglass area. Make sure that the detector’s field of view isnot blocked by any object. Avoid installation in the following locations: Areas with substantial air current. Areas with high audio noise orvibrations. Detector’s detection range may bedecreased in a place with acousticallyabsorbing material.2. MOUNTING Determine mounting position and cablerouting. Open the front cover by pressing the cliplocated on the mid-right side with ascrewdriver, and pull it upward. Run the cable along the cable-duct locatedon the backside of the rear cover and insertit through its prepared hole. Mount the rear cover to the wall/corner asdetermined previously. Connect the wires to the terminal block(according to the terminal block diagram.) Close the detector case.the terminal block located on the PCB.(like followingfig.)1. replace the front cover until the closing click isheard.Terminal output Terminal 3&4—marked ”TAMPER”If a tamper function is required, connect theseterminals to the control unit. When the front coverof the detector is opened, an immediate alarmsignal will be sent to thecontrol unit. Terminal 5&6—marked ”RELAY”These are the output terminal contacts of thedetector. Terminal 1— -Connect to the negative polarity Terminal 2—+ Connect to the positive polarity