INSTRUCTION SHEETACDelco AGM PowerSports BatteriesCharging Instructions (New Batteries):New Battery Testing:When checking the condition of a new battery prior to installation, ACDelcorecommends only measuring open circuit voltage (OCV). ACDelco recommends aminimum installation OCV of 12.4volts.1. Batteries that fall below 12.4 volts should be recharged, prior to installation.2. The battery should be tested with a known, good Digital Volt Ohm Meter(DVOM).3. When testing side terminal or top stud batteries, always use Lead (Pb)terminal adapters. Make sure the terminal adapter makes good contact withthe Lead pad of the battery or inaccurate readings will result. Basic handtools may be needed to ensure the terminal is tight.4. Never use steal bolts/nuts/washers, etc., when testing a side terminalbattery.5. Never clamp the tester’s leads directly to the threads when testing a top studbattery with a conductance tester.Charging Instructions:1. Battery Preparationa. Let the battery stand on level surface. Remove the sealing sheet.2. Preparing the Electrolytea. Take the electrolyte container out of the inner box.NOTE: Do not peel or pierce the sealed areas.3. Procedure for filling battery with acida. Place electrolyte container upside down with the six sealed areas in linewith the six filler ports of the battery. Push the container down stronglyenough to break the seals. Now the electrolyte should start to flow out.