ACG EQ-02 Installation Instructions Manual
  |
The ACG pre-amp does not require any soldering all connections are made using screw terminals.Wiring key for the main board.This board is common to all configurations. Filter stack connection is now duplicated on the reverseof the board.1. Cold (-) input for neck pickup. Note: Use this Input for the Single Pickup version2. Hot (+) input for neck pickup. Note: Use this Input for the Single Pickup version3. Cold (-) input for bridge pickup. (N/A for Single Pickup version)4. Hot (+) input for bridge pickup. (N/A for Single Pickup version)5. Gain control for neck pickup.(0-+12dB) ) Note: Use this Gain Control for the Single Pickup version6. Gain control for bridge pickup. (0-+12dB) (N/A for Single Pickup version)7. Positive connection for battery clip. (red wire)8. Output to jack socket. (Orange wire tip on jack socket)9. Ground (green wire ground on jack socket)ACG EQ-02Pre-amp installation instructions.Wiring key for the main board.This board is common to all configurations.1. Cold (-) input for neck pickup.2. Hot (+) input for neck input.3. Cold (-) input for bridge pickup.4. Hot (+) input for bridge pickup.5. Gain control for neck pickup. (0-+12dB)6. Gain control for bridge pickup. (0-+12dB)7. Positive connection for battery clip.8. Output to jack socket.9. Ground.ACG EQ-02Pre-amp installation instructions. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine