ACO PRO I/O Installation Manual
  |
INSTALLATION MANUAL FOR PRO I/O, PRO I/O–60GENERAL INFORMATIONPRO-I/O and PRO-I/O-60 modules are optional extensionmodules for PRO system with relay output and switchoutput. Both modules have equal function, differencebetween them is only visual.PRO-I/O module has standard ACO housing, possible tosuface mount (dimensions: 71x70,5x19,4 mm) and it hasRj45 socket and screw terminals for connecting the wires.PRO-I/O-60 is equipped only with screw terminals forwires connection, the size (cross-sections is 50 mm)allows putting the module into 60 mm electric back boxes.PRO-I/O module optionally extends the system with relayoutput and normally open (NO) input. The latter can beused to call certain receivers (from additional door bellbutton) or from remote opening activation (typicalactivation of e-lock).NC/NO contact points work either in monostable orbistable mode and they can be used to control additionalgate, lights or external calling signal can be connected toit.In case call incoming from the I/O module the receivershows the picture from the camera (if available) and startsto ring. Calling from the I/O module is shown by pulsatingkey icon and lasts for 10 s. and the receivers with handsetring with different tone. In order to enable the relay in theI/O module use F2 button (circle icon). Any action at thereceiver during incoming call from the module cancels thecall and enables the desired action. When the call signalmode is enabled, the I/O module enables the relay whilethere is call from the panel and when the module's inputgets the contact, the I/O module will automatically openthe door. When the input has a permanent contact, everycall from the panel will enable the relay for 1 s and willopen the door.The module can work also as a relay andtrigger the e-lock for the time set in the outside unit, itdoesn't concern opening from the INPUT function of theoutside station (this feature is available in the softwareversion of the module 2.1 and the panel's version fromv.1.1.5)TECHNICAL PARAMETERS• Power voltage 15VDC ±5%• Max. power consumption 35mA• Power consumption in standby ~0,14W• Contacts load 5A/250VAC• Type of external trigger NO switch• Resistance ≤ 20Ω• Contacts type NO/NC with common point COM• Sockets type RJ45 socket / screw terminals ARK• Work mode monostable / bistable• Additional calling type Normally open (NO)62-002 Suchy Las, ul. Diamentowa 7, tel./ fax + 48 61 843 93 71www.aco.com.pl/en |
Related manuals for ACO PRO I/O
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine