www.acobd.com/splashlightACO SplashLightInstallation Instructions NoteUnder normal conditions of use, a fully chargedmodule should last approximately three to sixmonths before needing to be charged again.For optimum performance, always keep theSplashLights fully charged to preserve lifespan.Installing ACO SplashLight1. Use a lifting key to remove the grate fromthe shower channel.Product DescriptionACO SplashLight contains two low-voltagebattery-operated LED units which fit directlyinto the ACO ShowerDrain Premium channelgrating. These units will illuminate once theycome in contact with water and will come offapproximately two minutes after the shower isturned off.Charging ACO SplashLightThe LED unit must be fully charged beforeinstalling for the first time. Make sure the LEDunit is clean and dry, then insert it into thecharger.Connect charging cord (USB-C) to walladapter (not included). The charging processcan take up to 24 hours to complete. Bothunits need to be charged before installation.Premium2. Remove the existing Bumper Pins from thesides of the grate.Technical DataLED Units:Pre-programmed to blue lights but can be altered.Please see ACO SplashLight ProgrammingInstructions or visit www.acobd.com/splashlight.Be sure to exercise extreme caution whenhandling electrical devices around water.!