ACR Electronics OLAS CORE Manual

Also see for OLAS CORE: Accuracy Testing Quick start guide Setup and Range Test Troubleshooting Setup and Range Test

ACR Electronics OLAS CORE Manual Manual pdf 1 page image

034711520438Near1152Near0347NearMOBID: 04381. Connect the ACR OLAS app to the Core. For moreinformation on how to do this please refer to the CoreSetup Instructions.Testing the alarmFOR FIRMWARE VERSION 2.0+2. Ensure all ACR OLAS transmitters are seen on the ACROLAS app homescreen.3. Switch off the ACR OLAS transmitters.OLAS tag: press the button for 4 seconds, until a red flash is seen.OLAS Float-On: press the button for 4 seconds until the bi-colourturns red.4. If testing with an ACR OLAS Tag or ACR OLASFloat-ON the alarm will occur after your set 'Alert Time'which has a default of 3 seconds. If testing with an ACROLAS T2 tag the alarm will occur immediately after it isswitched off.Press and hold the MOB buttonon your GPS Chart PlotterSend a MOB DSC alertusing your VHFTomOverboard!Step 1Step 2Continue to recovery5. Press the control switch on the Core once. This puts thesystem into pause.Press and hold the MOB buttonon your GPS Chart PlotterSend a MOB DSC alertusing your VHFTomOverboard!Step 1Step 2Continue to recoveryORMOB4. If using an ACR OLAS T2 go to 'Alert Settings' in themenu and select the alert function for the ACR OLAST2. Now when you switch off your ACR OLAS T2 tag itwill activate the alarm immediately.Alert SettingsSoundSiren (Default)VolumeDetection Time(seconds)7215Alert Delay(seconds)4230Pause Alert SoundOLAS T2 FunctionSwitch Active(seconds)56050438FarMOBTutorialsOnlineSolo ModeVesselInformationAlert SettingsDevice SelectionFAQ’sClose OLASFirmware Update0438NearMOBwww.acrolas.com

/ 2

Related manuals for ACR Electronics OLAS CORE