ADEMCO 5807 Installation Instructions Manual

Contents

installation instructions

ADEMCO 5807 Installation Instructions Manual Manual pdf 1 page image

165 Eileen Way, Syosset, New York 11791Copyright © 1998 Pittway CorporationàN6481V2]äN6481V2 5/98N6481V2 5/98® 5807SMOKE DETECTORwith BUILT-INWIRELESS TRANSMITTERINSTALLATION INSTRUCTIONSFor use with QED control panels ONLY!GENERAL INFORMATIONThe Ademco No. 5807 Photoelectric Smoke Detector/Transmitter is intended foruse with wireless alarm systems that support QED 5800 series devices, andcontains a built-in transmitter which can send alarm, supervisory and batterycondition messages to the system's QED receiver/control unit. Refer to thewireless system's instructions for the maximum number of transmitters that canbe supported.Alarms: The smoke detector is powered by two 9-volt batteries and will soundits built-in horn when smoke reaches the detector (and the LED indicator will lightsteadily). A message will also be sent to the wireless QED control and the smokedetector's ID number will be displayed at the console. The alarm message will betransmitted every 4 seconds, until the smoke condition has cleared and thedetector has reset. After the horn has stopped, a Restore message will betransmitted to the QED control and it will then be possible to clear the ID numberfrom the display. During normal or low battery conditions, the LED indicator willflash about once every 7 seconds.Low Battery: The detector indicates a low battery condition by emitting a "beep"about once every 15 seconds. A low battery message will be sent to the QEDcontrol unit upon any transmission following the first battery beep (with thedetector's ID number displayed at the console). The battery should be replacedwithin 7 days following the low battery signals.Programming: Note that the QED control system must “enroll” the smokedetector’s ID during installation of the system. The QED control should beprogrammed to “enroll” the 5807 as an “RF” type unit (i.e., supervised RF). SeethePROGRAMMING section in this instruction book and the QED control unit’sInstallation Instructions for further details.PRESSTESTTEST BUTTONRELEASE TABPOWER ON/ALARMINDICATORFigure 1. 5807 Smoke Detector