ADTRAN NETVANTA 1700515G2 120 Quick Start Manual

Also see for NetVanta 1335 Series: Quick reference guide Hardware installation guide Quick start guide Specifications Hardware installation guide

ADTRAN NETVANTA 1700515G2 120 Quick Start Manual Manual pdf 1 page image

Quick Start Guide, 61700515E2-13D, March 2011 1NET VANTA 1335 SERIESP/N 1700515G2#120, 1700515G2#240, 1700525E2GETTING STARTEDTwo configuration methods are available for your NetVanta unit:• Web-based graphical user interface (GUI)• ADTRAN Operating System (AOS) command line interface (CLI)The GUI lets you configure the main unit settings and provides online guidance and explanationsfor each setting. However, using the AOS CLI may be necessary for more advancedconfigurations.ACCESS THE GUIYou can access the GUI from any Web browser on your network by following these steps:1. Connect the unit to your PC using any of the ports on the front of the unit and an Ethernetcable.2. Set your PC to a fixed IP address of 10.10.10.2. To change your PC IP address, navigate toComputer > Control Panel > Network Connections > Local Area Connection >Properties > IP (TCP/IP) and select Use this IP Address. Enter these parameters:IP Address: 10.10.10.2Subnet Mask: 255.255.255.0Default Gateway: 10.10.10.1You do not need to enter any domain naming system (DNS) server information. After theinformation is entered, select Ok twice, and close the Network Connections dialog box. Ifyou cannot change the PC’s IP address, you will need to change the unit’s IP address usingthe CLI. (Refer to the next two sections for instructions.)3. Open a Web browser and enter the unit’s IP address in your browser address line as follows:http://10.10.10.1. The default IP address is 10.10.10.1, but if you had to change the unit’s IPaddress using the CLI, enter that address in the browser line.4. You will then be prompted for the user name and password (the default settings are adminand password).5. The initial GUI screen appears. You can access initial setup information by selecting SetupWizard from the menu on the left.ACCESS THE CLIAccess the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to theNetVanta unit’s CONSOLE port, you need the following items:• PC with VT100 terminal emulation software• Straight-through serial cable with a DB-9 (male) connector on one end and the appropriateinterface for your terminal or PC communication port on the other endYou can find VT100 terminal emulation software on most PCs bynavigating to Start > Programs > Accessories > Communications >HyperTerminal > HyperTerminal. When you have opened aHyperTerminal session, enter the settings described in Step 4.

/ 4

Related manuals for ADTRAN NetVanta 1335 Series