ADTRAN NETVANTA 3100 Series Quick Start Manual

Also see for NetVanta 3100 Series: Quick start guide Quick start guide Quick start guide Quick start guide Quick start

ADTRAN NETVANTA 3100 Series Quick Start Manual Manual pdf 1 page image

Quick Start Guide, 61700600L2-13E, March 2015 1NET VANTA 3100 S ERIES ROUTERWITH D IAL BACKUP UNITP/N 1700600L2, 1700610L2GETTING STARTEDTwo configuration methods are available for your NetVanta unit:• Web-based graphical user interface (GUI)• ADTRAN Operating System (AOS) command line interface (CLI)The GUI lets you configure the main unit settings, and provides online guidance, explanations foreach setting, and configuration wizards to help you get started. However, using the AOS CLI maybe necessary for more advanced configurations.ACCESS THE GUIYou may access the GUI from any web browser on your network by following these steps:1. Connect the router to your PC, using an Ethernet cable connected to one of the four ports onthe back of the unit (Ethernet 1, 2, 3, or 4).2. Set your PC to a fixed IP address in the 10.10.10.0 /24 subnet. For example configure yourPC with the following settings:IP Address: 10.10.10.2Subnet Mask: 255.255.255.0Neither a default gateway nor DNS server needs to be configured to connect to the unit. Ifyou cannot change your PC’s IP address, you will need to change the Unit’s IP addressusing the CLI as explained in the section below.3. Open a web browser and enter the unit’s IP address in your browser address line as follows:http://10.10.10.1. The default IP address is 10.10.10.1, but if you had to change the unit’s IPaddress using the CLI, enter that address in the browser line.4. You will then be prompted for the user name and password (the default settings are adminand password).5. The initial GUI screen appears. You can access initial setup information by selecting SetupWizard from the menu on the left.6. ADTRAN recommends changing the default password. Browse to System > Passwords. Inthe Login Configuration section, enter a new Username and Password and select ApplyChanges.CONFIGURE THE ATM PVC (NET VANTA 3130 O NLY)1. Select the Getting Started link under the System menu. This brings up a side bar menu.2. Select Step 1 - Configure the Public Interface at the top of the side bar menu to open theATM PVC menu.3. Enter the PVC number and select an Interface Mode. Usually this is PPP or PPPoE;however, if IP routing is chosen, you will need to enter an IP address.By default, the NetVanta 3130 comes with an ADSL and an asynchronoustransfer mode (ATM) port already configured and enabled. The serviceprovider should provide a PVC (VPI/VCI) number, which will be used toconfigure the ATM PVC.

/ 4

Related manuals for ADTRAN NetVanta 3100 Series