Quick Start Guide, 61200825G1-13A, February 2011 1NET VANTA OCTAL P OE U PGRADEP/N 4200825G1#120, 4200825G1#240GETTING STARTEDThe NetVanta Power over Ethernet (PoE) Upgrade provides the ability to detect attachedpowered devices (PDs) and deliver 48 VDC to the PDs via existing CAT 5 cabling. The NetVantaPoE Upgrade bundle is shipped with the Octal PoE module, two standoffs, the PoE power supply,and appropriate power cords.INSTALLING THE OCTAL P OE M ODULE1. Remove power and all connecting cables from the unit.2. Remove any installed network interface modules (NIMs), the screws holding the base unitand the cover together, the two jack screws from the back panel (if necessary), and the twomounting brackets (if necessary).3. Carefully lift and remove the unit’s cover to expose the main circuit board.4. Remove and retain the two PC board mounting screws (highlighted in Figure 1).5. Thread and secure the two standoffs (supplied with the Octal PoE module) into the twoholes from which you removed the PC board mounting screws (see Figure 1).6. Carefully align the 34-pin receptacle on the Octal PoE module with the 34-pin headerlocated on the circuit board. Applying even pressure, press the module until it is well seated.7. Align the holes in the standoffs with the holes in the Octal PoE module. Attach the module tothe standoffs using the two previously removed PC board mounting screws.8. Replace the unit cover, screws, mounting brackets, NIMs, and all connecting cables.9. If wall mounting the power supply, skip to steps given in Wall Mounting the PoE PowerSupply (Optional).10. Restore power to the unit following the instructions in Powering the NetVanta and PoESwitchports.Installation of the NetVanta Octal PoE module is not required on factory-installed upgrades.The NetVanta Octal PoE module is intended to be installed only byqualified service personnel.