ADTRAN NetVanta 1355 PWR Quick Start Manual

ADTRAN NetVanta 1355 PWR Quick Start Manual Manual pdf 1 page image

Quick Start Guide, 61200740L1-13A, March 2006 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright © 2006 ADTRAN, All Rights ReservedFor more detailed documentation, visit us online at www.adtran.com.Quick Start Guide®NetVanta 1355 PWR P/N 1200740L1POWER OVER E THERNETPower over Ethernet (PoE) technology provides the ability to detect attached Powered Devices(PDs) and deliver 48 VDC to the PD via existing CAT5 cabling. The NetVanta 1355 PWR units arefully compliant with the power delivery options called out in the IEEE 802.3af Power over Ethernetspecification. By default, the PoE interfaces discover and provide power to IEEE compliant PDs.To disable power detection and supply, use the power inline never command in the CLI. To disablepower detection and supply from the GUI, select the Ports page. Then select a single port from thelist (e.g., eth 0/1). This will bring up the port detail page for eth 0/1. On this page, there is a checkbox to enable power detection.GETTING STARTEDTwo configuration methods are available for your NetVanta 1355 PWR unit:• Web-based GUI• AOS Command Line Interface (CLI)The GUI lets you configure the main unit settings and provides online guidance and explanations foreach setting. However, using the AOS CLI may be necessary for more advanced configurations.ACCESS THE GUIYou can access the web-based GUI from any web browser on your network by following thesesteps:1. Connect the unit to your PC using the Ethernet (ETH 0/0) port on the rear of the unit.2. Set your PC to obtain an IP address automatically via Dynamic Host Configuration Protocol(DHCP), or change your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’sIP address, you will need to change the unit’s IP address using the CLI. (Refer to the next twosections for instructions.)3. Enter the unit’s IP address in your browser address line. The default IP address is 10.10.10.1.4. You will then be prompted for the username and password (the default settings are admin andpassword).5. The initial GUI screen appears.N ETVANTA 1355 PWR FRONT P ANEL L AYOUTACCESS THE CLIAccess the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to theNetVanta unit’s CONSOLE port, you need the following items:• VT100 terminal or PC (with VT100 terminal emulation software)• Straight-through serial cable with a DB-9 (male) connector on one end and the appropriateinterface for your terminal or PC communication port on the other end1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rearpanel of the unit.2. Connect the other end of the serial cable to the terminal or PC.3. Insert the connector of the provided power cord into the power interface on the rear panel ofthe unit, and plug the cord into a standard electrical outlet.4. Once the unit is powered up, open a VT100 terminal session using the following settings:9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press to activate the AOS CLI.5. Enter enable at the > prompt. Enter the enable password when prompted. The defaultpassword is password.The configuration parameters used in the examples outlined in thisdocument are for instructional purposes only. Please replace allunderlined entries (example) with your specific parameters to configureyour application.

/ 2

Related manuals for ADTRAN NetVanta 1355 PWR