ADTRAN NetVanta 3448 Quick Start Manual

Also see for NetVanta 3448: Quick reference guide Hardware installation guide Hardware installation guide Hardware installation guide Quick start guide

ADTRAN NetVanta 3448 Quick Start Manual Manual pdf 1 page image

Quick StartG ETTING STARTEDThis NetVanta unit ships with a statically assigned IP address of 10.10.10.1 and the abilityto connect to a Dynamic Host Control Protocol (DHCP) network and receive an IP addressassignment from a DHCP server. When connecting to a DHCP network, this unit supportsZero-Touch Provisioning, allowing the NetVanta router to download and apply configurationparameters from a configuration management server.Regardless of the method you use to connect the NetVanta unit to the network, there aretwo methods available for configuration:■ Web-based graphical user interface (GUI)■ ADTRAN Operating System (AOS) command line interface (CLI)The GUI lets you configure the main unit settings and provides online guidance and expla-nations for each setting. However, using the AOS CLI may be necessary for moreadvanced configurations.A CCESS THE GUIYou may access the GUI from a web browser in one of two ways:Connect via the Static Address1. Connect the router to your PC using the switch port labeled 1 on the back of the unit.2. Set your PC to a fixed IP address of 10.10.10.2. To change your PC IP address,navigate to Computer > Control Panel > Network Connections > Local AreaConnection > Properties > IP (TCP/IP) and select Use this IP Address. Enter theseparameters:■ IP Address: 10.10.10.2■ Subnet Mask: 255.255.255.0■ Default Gateway: 10.10.10.1You do not need to enter any DNS server information. After the information is entered,select OK twice, and close the Network Connections dialog box. If you cannot changethe PC’s IP address, you will need to change the unit’s IP address using the CLI.(Refer to the next two sections for instructions.)3. Open a web browser and enter the unit’s IP address in your browser address line asfollows: http://10.10.10.1. The default IP address is 10.10.10.1, but if you had tochange the unit’s IP address using the CLI, enter that address in the browser line.4. The initial GUI screen appears.Connect via the DHCP Client Address1. Connect the router to an existing network that supports DHCP using the switch portlabeled 1 on the back of the device. The NetVanta unit will automatically request an IPaddress assignment from the DHCP server.61200821F1-13B 1NetVantaNetVanta 3448 RouterOctober 201861200821F1-13BP/N: 1200821F1

/ 4

Related manuals for ADTRAN NetVanta 3448