ADVANCED Network Devices IPSIGN-O Installation Flyer
Outdoor IP Sign (IPSIGN-O)InstallationAdvanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004 • Fax: 847-359-5418Support: tech@anetd.com • 847-463-2237 • www.anetdsupport.comVersion 1.2 • 7/16/18INSTALLATION INSTRUCTIONS1. Remove the two wall brackets from the accessory box, and slide them into the slot on the bottom of the sign,and tighten all screws for all four brackets at the desired mounting locations. Screw brackets into the wallusing mounting hardware appropriate for the installation surface chosen.2. Remove the water-resistant network cable housing (required for outdoor installations) from the accessorybox, and attach it to a network cable (outdoor-rated CAT 5 or better), not included, threading the networkplug left to right as pictured below. The housing includes six pieces. Use the side openings on pieces B, C, andD to fit them around the network cable. The network plug will snap into place at the end of piece F as shown.Once fitting all pieces together, piece A will screw onto the threads of piece F.3. Plug in the included 7-foot AC power cord into an appropriate weatherproof GCFI receptacle.4. Connect the network cable housing (assembled in step 2) to the network coupler on the side of the IPSIGN-Oby inserting connector and twisting clockwise to lock and seal the interface. Connect the other end of thenetwork cable to a properly installed surge protector, then to a Power over Ethernet (PoE) network switch orPoE injector on a network with a DHCP server. The AND support site lists some equipment options:www.anetdsupport.com/peripherals.5. If properly installed, the unit should boot and show the time within 30 seconds. See Boot Sequence on nextpage for details.6. Consult the IPClockWise User Manual (see www.anetdsupport.com/documents) or third-party software guidefor further instructions on sending text to the device. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine