INSTRUCTION SHEETPEXCrimp ToolsPEX69PTKH00143 - 1/2"69PTKH00144 - 3/4"69PTKH0014C - 1/2" & 3/4"69PTKH0015K - 3/8"-1"1To remove and replace crimp heads: For 69PTKH0015K only (Heads cannot be replaced on all other Apollo® crimp tools)1. Cut tubing end squarely. Check for andremove any burrs.2. Slide crimp ring over end of tubing.Insert fitting into end of tubing until itstops. Position the crimp ring 1/8" to1/4" from the end of the tubing andover the ribs of the fitting.3. Place the crimping end of tool aroundthe crimp ring and press the handlestogether.4. Check for proper crimp with theGo/ No-Go gauge.1. With the handles. fullyopen, press side releasespring upward until thehook is above the jaw pin.3. With the side releasespring pressed upward,slide new jaw into placeand release the spring.2. Slide jaw out of positionand remove.2 3If you have a 69PTKH0015K that does not have springloaded jaws, but jaws that are secured with screws, sim-ply loosen the screws located at the center of the jaws.Remove the jaws and slide the jaws you need into place.Replace the screws at the center of the jaws and tighten.Apollo® PEX Crimp RingsAPXCR3810PK 3/8" 10 PackAPXCR1210PK 1/2" 10 PackAPXCR1225PK 1/2" 25 PackAPXCR1250PK 1/2" 50 PackAPXCR12100PK 1/2" 100 PackAPXCR3410PK 3/4" 10 PackAPXCR3425PK 3/4" 25 PackAPXCR34100PK 3/4" 100 PackAPXCR15PK 1" 5 PackAPXCR125PK 1" 25 PackApollo® PEX PRO Crimp RingsAPXCR12LT 1/2" 10 PackAPXCR34LT 3/4" 10 PackConbraco Industries, Inc.Matthews, NC 281051.888.229.2874www.apolloflow.com