A&C Green Energy PM10-24 Owner's Manual
Also see for PM10-24: Owner's manual
Wind/Solar Hybrid ControllerPM10-24 (1000W) and PM 20-48 (2000W)Owner’s Manual1. SecurityIMPORTANT: To prevent bodily injury or property damage, please follow theseinstructions precisely. With personal safety as a primary focus in design, this chargecontroller has been engineered to function properly and efficiently.1. Professional installation and guidance is always recommended. Otherwise, pleasecontact your authorized PowerMax+ agent before installation.2. Keep the charge controller dry. Do not clean with a wet or damp cloth. This is anelectric device and cannot get wet at all. Prevent any spills on or near thecontroller.3. Keep all children and any person with limited understanding and/or decreasedmental capacity away from the controller.4. Keep the controller away from direct sunlight or any other heat source.5. Please check the rated voltages of your wind turbine, solar panel and batterybefore connection. Their rated voltages all should be the same.6. Pay close attention to the connection of your wind turbine, solar panels andbatteries to make sure positive goes to positive and negative goes to negative.7. Smaller gauge wires should not be used with higher current equipment.8. Ensure that all component connections are tight and secure.9. DO NOT TOUCH any bare parts on the controller. The high voltage can causelethal shock.2. General DescriptionYour PowerMax+ wind/solar hybrid controller is designed to control the wind powercharging battery under constant voltage. In addition, it includes a solar charging control,which makes it good for wind/solar hybrid application.At the right side of the controller, there is a manual brake switch. If the switch is turnedto the ‘brake’ position, the wind turbine will be manually stopped.3. Connection1. Turn the ‘manual brake’ to the ‘BRAKE’ position, and then connect the output ofthe wind generator to the ‘WIND INPUT’ terminals using 10mm2 cable.2. If applicable, connect the output of your solar panel to the ‘SOLAR INPUT’terminals on the PowerMax+ controller. Positive to positive, negative to negative.3. Using 10mm2 cables, connect the battery’s positive pole to the positive (+)‘battery’ terminal on the controller and connect the battery’s negative pole to thenegative (-) ‘battery’ terminal on the controller. The length of the cables should beno longer than three (3) feet. Tighten the nut on each ‘battery’ terminal by hand.Do not over tighten.4. Turn the ‘manual brake’ to the ‘RUN’ position.All manuals and user guides at all-guides.comall-guides.com |
Related manuals for A&C Green Energy PM10-24
manualsdatabase
Your AI-powered manual search engine