Abicor Binzel SI4 Series Instructions Manual

Abicor Binzel SI4 Series Instructions Manual Manual pdf 1 page image

T e c h n o l o g y f o r T h e W e l d e r ’ s W o r l d .www.binzel-abicor.comABIcor BInZel corporation650 Medimmune court, suite 110frederick, Md 21703Phone: (301) 846-4196fax: (301) 846-4497ABIROB W Liner InstructionsSI4-XXX Series LinersLINCOLN DIRECT TORCHES1. Position the torch cable as straight as possible.2. With the torch neck and consumables fitted, insert the liner into the rear of the torch until it bottoms in the tipholder/tip or wire-brake if fitted.3. At the rear end of the torch measure the distance from the feeder plug to the end of the liner collet (Fig. 1). This isdimension “X”.4. Remove the liner from the torch and remove the dimension “X” from the front end of the liner (Fig. 2).5. At the rear end of the liner, you must trim the excess liner which protrudes from the liner collet. Measure 4mmpast the collet and cut the excess off (Fig. 3). Note: When cut properly the liner should be flush to 1mm recessed inthe liner nut.6. Apply O-ring grease. Install the liner into the torch and tighten the liner retention nut (Fig. 4).Fig. 1Fig. 2Fig. 3Fig. 4liner liner colletX4mmliner retention nutXcutINT.9034 ABIROB W Liner Instructions - Lincoln • 04-14 © 2014 Alexander Binzel Corporation • Printed in USAFeeder plug(Miller Direct Torcheson back...)

/ 2

Related manuals for Abicor Binzel ABIROB W Series