Abitana ABI-ET2001 Quick Start Manual
    |
090810_ABI-ET2001_QSG_MLEnglish Page 9 N.V. abitana S.A.ENGLISHABI-ET2001Telephone Connection Module4 linesQuick Start Guide1 Package Contents• Telephone Connection Module 4 lines• Quick Start Guide2 IntroductionThe ABI-ET2001 is a passive telephone distribution module suitable forstandard (PSTN) and digital (ISDN) phone lines.This unit provides easy connection of Telephone, FAX and/or ISDNequipment like Telephones, modems or bank terminalsThe ABI-ET2001 does not have a privacy protection deviceincorporated.3 Hardware IntroductionP1 P2 P3ISDN L1L2P4PositieA <-> BFigure 1The DIN-Rail mountable ABI-ET2001 is equipped with 4 RJ45 jacks onthe front of the unit. (P1 ~ P4)Three switches on the front of the unit are used to configure the unitaccording to the needs of your installation. Different configurationscenarios are explained later in this manual.On the top of the unit you’ll find the connections for the ‘incoming’phone linesThe switches and the incoming phone line connections are onlyaccessible when the front of the ‘Comm Center Cabinet’ is removed.The unit will probably be configured during installation. Make sure totake note of the configuration (Connections to the rear ports and switchsettings). At the end of this manual, you will find a table where you canwrite down the configuration.4 Installation and powerNo power needed.Load ratio for this module = 0.Maximum allowed load ratio (sum of the load ratios for all modules) forpower supply ABI-PS1001S00 = 4.Click the module on the DIN-Rail as shown in the pictures below:5 Installation scenariosThe switches on the front of the unit (see Figure 1) )can be placed intwo positions (A and B). A number of combinations is possible, but notall possible combinations are allowed (depending on the externalconnections to ISDN, L1 and L2, and the connected devices to P1 ~P4)5.1 One analog (PSTN) phone lineWhen you have one incoming telephone line (standard PSTN), youcan distribute the signal to 4 locations in parallel.When a call arrives, all phones will ring at the same time. You can pick-up any of the four phones to answer the call.If during a call a second phone is unhooked, this phone will join theongoing conversation.No internal calls between the locations are possible (NO PABXfunction).Switch Nr. PositionS1 AS2 AS3 AFor this configuration, the switches must be in the positions indicatedin the preceding table. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine