Luminator LED Trio Light KitModel 12.5064General Information:The Luminator LED Trio Light is equipped with an internal flasher. It comes from the factory in a random flash mode.Product Specifications:Optimum Operation Voltage: +13.8 VDCOperating Current: 1.5 - 3 ampsRecommended Fuse: 5 ampFlash Pattern Selection:To change flash patterns, momentarily apply +12v to the Yellow "Sync-Mode" Wire for less than 5 seconds.To reset to factory default pattern, apply +12v to the Yellow "Sync-Mode" Wire for more than 5 seconds.**Do Not ground YELLOW WireWhen changing flash patterns, you may have to re-start before patterns will synchronize.Synchronization:Connect all yellow wires together to synchronize. When wired as shown, the Luminator LED Trio Light will besynchronized.Group Selection:The White "Group Selection" Wire will determine which lights flash at the same time when you have 2 or more lights.For Group 1, connect White "Group Selection" wire with Red Power wire.For Group 2, DO NOT connect White "Group Selection" wire to anything.Group 1 & Group 2 will alternate.*Do Not use White wire if using only one light.*Wiring Instructions:When wiring, always connect ground wire first and power wire last.Flash Patterns1. Single Flash - 134 FPM2. Double Flash - 268 FPM3. Quad Flash - 536 FPM4. Super Flash - 1070 FPM5. Single-On - 134 FPM6. Quad-On - 536 FPM7. Triple Flash - 401 FPM8. Hyper Flash - 1873 FPM9. Steady10. Random 1-8 (Default)09-10-08