Abode Storm Slimline AB2463 Manual
Important Technical Data:Minimum water pressure: AB2463 = 0.4 bar (No limiter) 0.5 bar (with limiter)Maximum operating pressure 5 bar*Maximum recommended hot water temperature 70°C*Note: If these pressures or temperatures are exceeded, even for short periods, damage can result.In these instances a pressure reducing valve or TMV should be installed.For manual mixing products we recommend the installation of a separate TMV2 product to reducethe risk of accidental scalding.All thermostatic products should be tested and cleaned at least once a year.When drilling or preparing walls take care not to disturb existing water or electrical supplies that maybe buried within the wall.Supply pipes should maintain the maximum diameter until immediately before the fitting.Hot and cold supply pressures should be as closely balanced as possible for best results. Thedifferential between the hot and cold water supply temperatures should be sufficient to allow correctmixing function.Where hot and cold supply pressures are greatly imbalanced flow restricting valves or pressurereducing valves should be installed on the supply with the greater incoming pressure.Abode products are either WRAS approved or manufactured in accordance with recognisedEuropean standards. Please ensure that your Abode product is fitted in accordance with LocalWater Byelaws. Where hot and cold water mix within any product, then suitable non return valvesshould be installed to the hot and cold supplies to prevent backflow.Whilst assembling this product take care not to accidentally loosen any screwed assemblies. PTFEtape can be used to ensure watertight joins on threaded connections, do not over tightenconnections or allow pipes to be twisted or folded.The installation should be periodically checked for damage, if the property is left unattended for aprolonged period we recommend isolating water supplies.All errors and omissions excepted.Manufacturers Reference©Abode 09/2017Unit L, Zenith Park, Whaley Road, Barnsley,S75 1HT.Tel: 01226 283434 Fax: 01226 282434www.abodedesigns.co.ukStorm Slimline 3mm Wall Mounted Waterfall Showerhead5 Year Warranty Terms & Conditions:In the unlikely event that you shouldexperience any defect in the materials orworkmanship of your new Abode product withinFIVE years of purchase, the purchaser’s soleremedy shall be the replacement (at themanufacturer’s discretion) of all or any part ofthe product that is defective. Valves areguaranteed for a period of FIVE years frompurchase. Decorative surface finishes and O-rings are guaranteed for ONE year from thedate of purchase provided that our adviceconcerning care has been observed and noscouring agents have been used.This is provided that the product has beenused for normal domestic purposes in the UKand that the care, installation and maintenanceinstructions have been observed. The warrantyextends to the original purchaser only. Youshould retain a copy of your dated invoice asproof of purchase to validate any claims underthis warranty.Marks and scratches caused by improperinstallation or accidental damage are notcovered by this guarantee. Neither are shadevariations or any damage or defect caused byincorrect installation or abuse of the fitting.As we are continuously improving anddeveloping our products range, finishes &colours, in the event of a valid claim, we maynot be able to provide an identical replacementfor the defective product throughout thewarranty period. Where an identical product isno longer available, we will supply the nearestequivalent from our then current product range.In assessing your claim, we must be given theopportunity to inspect the product as installedprior to removal. Any product returns must bepackaged carefully as received and complete.No other warranties, express or implied, aremade, including merchantability or fitness for aparticular purpose. Under no circumstancesshall the manufacturer be liable for any loss ordamage arising from the purchase, use orinability to use this product, or for any special,indirect, incidental or consequential damages.No liability is accepted for consequentialdamage to other household fixtures, fittings orfurnishings arising from this claim, even ifattached to the product. No installer, dealer,agent or employee of Abode Home ProductsLimited has the authority to modify theobligations or limitations of this warranty.Product Care Instructions:To maintain the appearance of this product, ensure that it is regularly cleaned only using a clean, softdamp cloth. A solution of warm water and a mild liquid detergent may be used where necessary, andthen the fitting rinsed thoroughly and wiped dry. Any other cleaning action or cleaning products willinvalidate your warranty.Abrasive cleaners, scouring cleaners, limescale cleaners and acidic cleaners must not be usedunder any circumstances. Avoid contact with all solvents (including chlorinated solvents, ketones oracetones as these may result in surface deterioration or etching). Also avoid contact with any harshhousehold chemicals such as bleach cleaners, drain cleaners, rust removers, paint strippers andtoilet bowl cleaners, toothpaste, mouthwash, bar keepers friend or Brasso.If the product has a spout aerator it can be unscrewed and cleaned periodically in warm water tomaintain flow. Sprayheads have ‘rub clean’ nozzles to reduce any limescale build up.Please leave these instructions for your customer. |
Related manuals for Abode Storm Slimline AB2463
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine