Absolute Process Instruments Cecomp DPG1000DR Series Instructions Manual

Absolute Process Instruments Cecomp DPG1000DR Series Instructions Manual Manual pdf 1 page image

Cecomp® 4-Wire Digital Pressure Transmitters DPG1000DR, F4DRRanges and ResolutionSee table below for popular ranges. Consult factory for specialengineering units. Resolution is fixed as indicated. See ourF16DR series for ranges greater than 2000 or if more displayresolution is required.DPG1000DRO ±0.25% Test Gauge AccuracyO 316 Stainless Steel Wetted PartsO Low Voltage PoweredO 4-20 mA or 0-2 V Analog OutputO Output Test FunctionF4DRAccuracyAccuracy includes linearity, hysteresis, repeatabilityStandard accuracy: ±0.25% of full scale ±1 least significantdigitHA accuracy option: ±0.1% FS ±1 LSD, see ranges foravailabilitySensor hysteresis: ±0.015% FS, included in accuracySensor repeatability: ±0.01% FS, included in accuracyDisplay3.5 digit LCD, 0.5" digit height (indicates to 1999)3 readings per second nominal display update rateDRBL: Red LED backlightControlsNon-interactive zero and span, ±10% rangeOutput test adjustment: 0-100% rangeRetransmission zero and span: Internal potentiometersOutput CharacteristicsTrue analog output, 50 millisecond typical response time-I version: Current output, 4-20 mA DC, output drive(compliance) determined by power source.See graph on other side.-V version: Voltage output, 0-2 VDC into 5k ohm or greater.Output is 0-1-2 V with ±15 psi sensor.Test FunctionFront panel TEST button, when depressed sets loop currentand display to output test level, independent of pressureinput, to allow testing of system operation.Power8-24 VAC 50/60 Hz or 9-32 VDCUse with WMPSK 115 VAC/12 VDC power supplyGauge is on whenever power is appliedDesigned for continuous operationDR: 30 mA maximumDRBL: Approximately 40 mA maximumWeight9.5 ounces (approx.)Shipping wt. 1 pound (approx.)HousingDPG1000DR: Extruded aluminum case, epoxy powder coated,ABS/ polycarbonate bezel (aluminum bezel optional), front andrear gaskets, polycarbonate labelF4DR: ABS/polycarbonate NEMA 4X case, rear gasket, poly-carbonate labelConnection, Material, Media Compatibility1/4" NPT male fitting, 316L stainless steelAll wetted parts are 316L stainless steelCompatible with most liquids and gasesOverpressure2 X pressure range for 3 psi to 2000 psi sensors5000 psig for ranges using 3000 psig sensor7500 psig for ranges using 5000 psig sensorVacuum service: 15 psia, ±15 psig, 15 psig, 30 psia,100 psig, 100 psia, 200 psig sensorsBurst Pressure4 X sensor pressure rating or 10,000 psi, whichever is lessEnvironmentalStorage temperature: –40 to 203°F (–40 to 95°C)Operating temperature: –4 to 185°F (–20 to 85°C)Compensated temperature: 32 to 158°F (0 to 70°C)¼" NPT2.88"3.38" Standard3.5" NEMA 4X0.75"2.0"Cecomp Electronics / Made in USA1.65"NEMA 4X3.0"StandardSpan ZeroTest3 ft long 4-conductor22 AWG shieldedcable with strippedand tinned wire endsTESTPotentiometercovers (3)Standard:plastic capsNEMA 4X:nylon screwswith o-ringsTurn at hexfitting only† -HA option is for output only and not supported by display‡ -HA option not availablePSI Res inH2O Res mmH2O Res3PSIG‡ .01 85INH2OG‡ .1 2000MMH2OG‡ 15PSIG‡ .01 140INH2OG‡ .1 cmH2O Res15PSIA .01 400INH2OA 1 200CMH2OG‡ .115PSIVAC‡ .01 400INH2OVAC‡ 1 350CMH2OG‡ 1±15PSIG‡ .1 ±400INH2OG‡ 1 1000CMH2OA 115PSIG .01 400INH2OG 1 1000CMH2OVAC‡ 130PSIA† .1 850INH2OA 1 ±1000CMH2OG‡ 130PSIG† .1 850INH2OG 1 1000CMH2OG 160PSIG .1 ftH2O Res 2000CMH2OA‡ 1100PSIA .1 7FTH2O‡ .01 2000CMH2OG 1100PSIG .1 12FTH2O‡ .01 kPa Res200PSIG .1 35FTH2O† .1 20KPAG‡ .01300PSIG† 1 70FTH2O .1 35KPAG‡ .1500PSIG 1 140FTH2O .1 100KPAA .11000PSIG 1 230FTH2O† 1 100KPAVAC‡ .12000PSIG 1 480FTH2O 1 ±100KPAG‡ .1oz/in2 Res 700FTH2O 1 100KPAG .150ZING‡ .1 1150FTH2O 1 200KPAA .180ZING‡ .1 mmHg Res 200KPAG .1240ZINA‡ 1 150MMHGG‡ .1 400KPAG 1240ZINVAC‡ 1 260MMHGG‡ 1 700KPAA 1±240ZING‡ 1 760MMHGA 1 700KPAG 1240ZING† 1 760MMHGVAC‡ 1 1400KPAG 1480ZINA‡ 1 ±760MMHGG‡ 1 2000KPAG 1480ZING 1 760MMHGG 1 MPa ResinHg Res 1600MMHGA 1 1.4MPAG .0016INHGG‡ .01 1600MMHGG 1 2MPAG .00110INHGG‡ .01 Torr Res 3.5MPAG† .0130INHGA† .1 760TORRA 1 7MPAG .0130INHGVAC‡ .1 760TORRVAC‡ 1 14MPAG .01±30INHGG‡ .1 1600TORRA 1 20MPAG .0130INHGG† .1 mbar Res 35MPAG† .160INHGA .1 200MBARG‡ .1 g/cm2 Res60INHGG .1 350MBARG‡ 1 200GCMG‡ .1120INHGG .1 1000MBARA 1 350GCMG‡ 1200INHGA .1 1000MBARVAC‡ 1 1000GCMA 1200INHGG .1 ±1000MBARG‡ 1 1000GCMVAC‡ 1400INHGG 1 1000MBARG 1 ±1000GCMG‡ 1600INHGG 1 2000MBAR 1 1000GCMG 11000INHGG 1 2000MBARG 1 2000GCMA 12000INHGG 1 bar Res 2000GCMG 1atm Res 1BARA .001 kg/cm2 Res1ATMA .001 1BARVAC‡ .001 1KGCMA .0011ATMVAC‡ .001 ±1BARG‡ .001 1KGCMVAC‡ .001±1ATMG‡ .001 1BARG .001 ±1KGCMG‡ .0011ATMG .001 2BARA .001 1KGCMG .0012ATMA .001 2BARG .001 2KGCMA .0012ATMG .001 4BARG .01 2KGCMG .0014ATMG .01 7BARA .01 4KGCMG .017ATMA .01 7BARG .01 7KGCMA .017ATMG .01 14BARG .01 7KGCMG .0114ATMG .01 20BARG .01 14KGCMG .0120ATMG .01 35BARG† .1 20KGCMG .0134ATMG† .1 70BARG .1 35KGCMG† .170ATMG .1 140BARG .1 70KGCMG .1140ATMG .1 200BARG .1 140KGCMG .1200ATMG .1 350BARG† 1 200KGCMG .1340ATMG† 1 350KGCMG† 1How to Specify TypeDPG1000DR range - output - options Standard housingDPG1000DRBL range - output - options Standard housing,backlit displayF4DR range - output - options NEMA 4X housingF4DRBL range - output - options NEMA 4X housing,backlit displayOptions—add to end of model numberHA High accuracy, ±0.1% FS ±1 LSD. See table at left foravailability.PM Panel mount, 4.1" x 4.1", n/a NEMA 4XCC Moisture resistant circuit board conformal coatingCD Calibration data; 5 test points and dateNC NIST traceability documentation, 5 points and dateAccessories—order separatelyWMPSK Wall mount power supply kit, 115 VAC/12 VDCG = gauge reference pressureVAC = gauge reference vacuumA = absolute referenceRange codes listed as 2, 20, 200, or 2000 display 1.999, 19.99,199.9, or 1999 respectively.OutputSpecify: I 4-20 mAV 0-2 Vpsi = PSIinHg = INHGoz/in2 = ZINinH2O = INH2OftH2O = FTH2OmmHg = MMHGtorr = TORRmmH2O = MMH2Okg/cm2 = KGCMg/cm2 = GCMkPa = KPAMPa = MPAmbar = MBARbar = BARcmH2O = CMH2Oatm = ATMRange—see table at leftH H H H H HH H H H HH H H H H HH H H H HH H H H H HH H H H HH H H H H HH H H H HH H H H H HMade in USAQuick Link cecomp.com/transSCR14SSFilter screen fitting keeps debris out of gaugesensor. Use for food vacuum packaging applica-tions. 303 SS body, 100 micron 304 SS screen.NEMA 4XHousing© 08-18cecomp.com1220 American Way Libertyville, IL 60048800-942-0315CECOMP Div. of ABSOLUTE PROCESS INSTRUMENTSAllow 1"clearanceAllow 1"clearance

/ 2

Related manuals for Absolute Process Instruments Cecomp DPG1000DR Series