NOTE!!! TIPS ON CONNECTING YOUR RADIO GEAR AND SOMEADDITIONAL INFORMATION:BOARD TOP VIEWWARNING!!! ALL SETUP PROCEDURES SHOULD BE DONEWITHOUTPROPELLERS INSTALLED!!!RECEIVER CONNECTIONS:With the connector facing out, the pins are used as follows. Unmarked pin(left-most top side) is ground, pin marked with dot is 5V supply, the rest areRC signal pins for CPPM (channel 1) or channels 1 through 8.Standard female to female servo cable can be used to connect a CPPM receiver. Default channel order isAIL, ELE, THR, RUD, AUX1..AUX4. A breakout cable is provided for connection to standard receiver.STANDARD(PCM) RECEIVER:Connect AIL to 1, ELE to 2, THR to 5, RUD to 6, and AUX1/2 to channels 7 and 8.FUTABA SBUS RECEIVERConnect SIGNAL INVERTER (GROUND to G pin, +5v to pin marked «•» and SIGNAL to pin 4(bottom row)

Abusemark NAZE32 Setup Manual