– 1 –Qu ic k Start G u ideE052024-CS-R02150200002668A64-Port 800G Ethernet SwitchAS9817-64O1. 64-Port 800G Ethernet Switch AS9817-64O2. Slide-rail mounting kit—2 rack slide-rails and install guide3. AC power cord, type IEC C20 (included with AC PSUs only)4. DC power cord (included with DC PSUs only)5. Documentation—Quick Start Guide (this document) and Safetyand Regulatory Information1. 64 x 800G OSFP800 ports2. Management Ports: 1 x 1000BASE-T RJ-45, 2 x 25G SFP28,RJ-45 console, USB3. Timing Ports: 1PPS, 10 MHz, TOD4. System LEDs5. 2 x grounding screws6. 2 x AC or DC PSUs7. 4 x fan trays1 6 73 524Fan Tray Replacement1. Pull the handle release latch.2. Remove the fan tray from thechassis.3. Install a replacement fan withmatching airflow direction.PSU Replacement1. Remove the power cord.2. Press the release latch andremove the PSU.3. Install replacement PSU withmatching airflow direction.Caution: During switch operation, fan replacement shouldbe completed within two minutes to prevent the switch shuttingdown due to its built-in over-temperature protection.Attention: Pendant le fonctionnement du commutateur, leremplacement du ventilateur doit être effectué dans les deuxminutes pour éviter que le commutateur ne s'arrête en raisonde sa protection intégrée contre la surchauffe.Package ContentsOverviewFRU Replacement1. OSFP800 LEDs: Purple (800G), Blue (400G), Cyan (200G),Green (100G), Red (50G)2. RJ-45 MGMT LEDs: Left: Green (link/act), Right: Green (speed)3. SFP28 LEDs: Green (link/activity)4. System LEDs:LOC: Flashing Green (switch locator)DIAG: Green (OK), Red (fault)ALRM: Red (fault)FAN: Green (OK), Red (fault)PSU1/PSU2: Green (OK), Red (fault)5. RST: Reset button122354System LEDs/Buttons1 2 3 5www.accton.com4