118 S. Main St ***Suite 9 -Wauconda, IL 60084 - 847-224-7914PM42 Breakout Board Installation InstructionsThe breakout board eliminates soldering connections to the card edge or card edgeadapter of a PM42 circuit breaker/reverser board.Making Connections:Strip approximately .125" (1/8 inch) off your wire. Either solid or stranded wire canbe used, from 12 AWG to 26 AWG. Insert the bare portion of the wire into the terminalblock and tighten the screw to make a solid connection.Do not over-tighten , as the terminal blocks can be stripped or broken with toomuch force.The instructions on the next page describe the board and connections as if the largeconnector for the PM42 is at the top; matching the orientation of the picture above.