AccuMASTER 7434 User Manual
Also see for 7434: User guide
  |
SET 04840 Hytech DriveCarson CityNV 89706 USA1-775-885-4900E-mail:info@calculated.comcalculated.comUG7434E-DVisitAccuMASTER.comto see our entireline ofAccuMASTERprecisionmeasuring tools.DIGITAL ANGLE GAUGEUSER’S GUIDEModel 7434 v1.1Setting 0° CalibrationNote: The device is calibrated in thefactory for maximum accuracy.User can re-calibrate if necessary.1. Turn off the device and place it ona flat, smooth surface.2. While the device is still off,press the ON/OFF and HOLDbuttons together until the displayreads “CAL”.3. Press the HOLD button again andthe display will now read “CAL1”.4. Without picking up the device,rotate it 180° and press the HOLDbutton again. The display willnow read “CAL2”. The 0°calibration is now complete.Inclination IconAs shown in the drawings, theinclination icon shows you in whatdirection you need to move an objectto get to level. The direction ismeasured relative to the right side ofthe gauge.If the short line is above the longerline, the right side is high and needs tobe lowered. Note that the arrow pointsdown, the direction which the right sideof the gauge should be rotated.If the short line is below the longer line,the right side needs to be raised. Notethat the arrow points up, the directionwhich the right side of the gaugeshould be rotated.One large line indicates level, 0.0°.180° |
Related manuals for AccuMASTER 7434
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine