Accuglide EzTilt Instructions Manual
    |
EzTilt Table DIY top InstructionsMaterial List:1. (10) 3 x 5’ HardiBacker® Cement Board Sheets2. (4) 3 x 5’ Wonderboard Cement Board Sheets3. (5) Silicone or latex caulking tubes4. (1) 50lb Bag thin-set material with acrylic latex additiveTool List:• Hammer Drill• 1/4” Masonry Drill Bit• Jig saw• Bi-metal jig saw blade• Impact Screw Gun or Ratchet wrench• 7/16” Socket• Grinder or saw• Diamond Blade• Caulking gun• 2 1/4 hole saw bit• 1/4” Notched trowel• (2) 5 gallon bucket• Paddle mixer for drill• Tile sponge• 12 and 6’ straight edge (or use your AccuGlideTracks)Material Cut ListA. (4 Pc.) 36 x 60” (full sheet)B. (4 pc.) 35 x 60”C. (1 pc) 15 3/4 x 35”D. (1 pc) 15 3/4 x 36”E. (1 pc) 16 1/2 x 35”F. (1 pc) 16 1/2 x 36”3) Calking the Joints:Spread a bead of caulk were the 2nd layer willoverlap with the 1st layer of cement board. Thisstep will ensure correct water drainage. Workquickly to step 4 before caulk sets up.Installing HardiBacker® Board Layers1) Preparing table for the Cement Board:Install the cement board while the table is inthe vertical position. To prepare the table forstacking, first clamp supports on the bottom ofthe table (G. Orange Rectangles). Ensure thesupports are strong enough to handle the load ofthe cement board. 4 x18” strips of wood, metalor granite can be used . Clamp to the 3x3” tablebeam with 4-8” C-Clamps.2) Stacking the 1st layer:Stack the 1st layer as depicted in figure 1. Referto the cut list above for specific dimensions oneach piece.A. F. A.B. E. B.G.Figure 1: 1st Layer |
Related manuals for Accuglide EzTilt
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine