Accutrol ZPS-H Quick Start Manual
    |
www.accutrolllc.com 1 ZPS-H QUICK START GUIDE Rev. L 11/4/2020Note: Please read this entire document to familiarize yourself with the installation and wiringinstructions for the ZPS-H Hood Presence Sensor. For additional details, refer to the individual productSubmittal Drawings, User Manuals and Job-Specific Requirements.OVERVIEWThe ZPS-H Zone Presence Sensor is an optional sensor used with the AVC Fume Hood Control System, which willcause the Fume Hood Monitor to revert to the Setback mode when no one is standing in front of the hood thus reducingthe exhaust requirements. Upon the return of the occupant to the front of the hood, the ZPS-H will immediately signalthe AVC Fume Hood Control System to return to the normal working velocity set point.STEP 1: INSTALLATIONCaution: Wear eye protection, cut resistant gloves and clothing suitable for working with sheet metal.Failure to do so may result in personal injury.1a. LocationSelect a flat surface on the front of the fume hood above the operator. Verify there is enough clearance behind thepanel to accommodate the two mounting screws and the cable. If the location is suitable, adhere the mounting templateto the surface.1b. Prepare the AreaUsing the mounting template as a guide, drill two holes for the mounting screws and one hole for the cable.Caution: Be sure to deburr the cable hole prior to inserting cable through the hole to prevent cabledamage.Insert the provided cable through the hole from the front of the hood so that the terminal block is on the front of thepanel. Insert mounting screws provided with kit partially, leaving space under the screw heads to slip the sensors slottedholes under.Power Cable and partially installed Screw Insert Screwdriver and Pry Upwards to Remove CoverQuick Start GuideZPS-H (Zone Presence Sensor for Fume Hood Applications)SashTo AVCExhaust DuctFront Hood PanelZPS-H (On top ofHood)Pictured is the top-down view of the hoodshowing ZPS-H cable routing. Be sure thesash and any of its moving parts do notinterfere with the Zone Presence SensorCable. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine