Ace Acetrap15N User Manual
  |
Balance lineBalance lineDedicatedstrainerOutletInletType AType BUSER GUIDEBe sure to read the user guide before installationand use.The product warranty is included in the user guide.www.acetrap.com1. Thank you very much for purchasing this product.2. Please read this manual thoroughly before using the product and keep it inan easy-to-find place.3. In order to fully demonstrate the performance of this product, please observethe operation method and precautions for use.-This manual is intended to protect users' safety and prevent property damage.-Be sure to read it and use it correctlyyoutube search : acetraphttps://youtu.be/VSvrPt3-zWMInstallation_receiver tank, etc.Inlet connection Among the two inlets on the side,according to the level of the inlet, connect using a ball valveand union as shown in the figure. The connecting inletshould have a horizontal or downward sloping flow andshould not be angled upwards, such as on a camel, toconnect to the trap. This is because condensate does notnaturally flow into the trap.Balance line Use a pneumatic hose or metal tube(6-8 mm) to connect a balance line with the same pressureas the inlet pressure. The balance line is usually taken froma level above the level where the condensate collects(mainly from the gauge if it is a tank).for compressed air systemATM C2000-08ACETRAP ®ACE Co.,LtdReceive TankFilterField endDryerIf the balance line is notinstalled, condensate doesnot flow into the trap due tothe air pocket phenomenon.It doesn't work.CautionCautionCautionCaution If there is strong vibration (reciprocatingcompressor) in the inlet line, use a flexiblehose, etc. to block the vibration.(Air pocket1 Tip :https://acetrap.com/eng/acetrap/installation.htmlType CAlways install trapshorizontally.Do not installupside down.(Air vent2 installation Tip :https://acetrap.com/eng/acetrap/installation.htmlTo facilitate the inflow of condensate in places where it isdifficult to connect the balance line, install Air Vent2.In this case, use the lower of the two on the side of thehousing for the inlet, and install the air vent on the side ofthe balance line on the top of the housing. Air vents areoptional and must be ordered separately.This installation method is used whenthe inlet line goes from top to bottomwithout bending. In this case, thebalance line is unnecessary, and youcan connect it directly to the top ofthe housing entrance as shown in thefigure.Installation where the inlet descendsfrom above_ Filters, field lines, etc.Installation in places where it is difficult toinstall a balance line_ Dryer, etc.InletAir ventDedicatedstrainerThe air vent shouldalways be slightlyopened, and it should bechecked frequently.(If it is not opened, condensate will not enter the trap andit will not work). |
Related manuals for Ace Acetrap15N
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine