EnglishAcer LCD Monitor Quick Start Guide (QSG)Important safety instructionsPlease read the following instructions carefully.1 To clean the LCD monitor screen:• Turn off the LCD monitor and unplug the power cord.• Spray a non-solvent cleaning solution onto a rag and clean the screen gently.2 Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage it.3 Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.4 Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing ofany nature.5 Store the LCD monitor in a room with a temperature of -20° to 60° C (-4° to 140° F). Storing the LCD monitor outside thisrange may result in permanent damage.6 Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:• Monitor-to-PC signal cable is frayed or damaged.• Liquid spills onto the LCD monitor or the monitor is exposed to rain.• The LCD monitor or case is damaged.Package contentsLCDmonitorUserguideQuickstartguideD-subcableACAdapterACPowercordHDMIcable(Optional)DVI cable(Optional)Audiocable(Optional)MHLcable(Optional)Adjusting the monitor base1 Carefully remove the monitor from its packaging.• The monitor base is attached onto the monitor before shipment and it is undetachable.2 Pull the monitor base out fully so that the monitor can be placed on a stable surface in the upright position.3 Secure the monitor base by turning the white screws (at the bottom of the base) using the integrated tab or a suitable coin.Connecting your monitor to a computer1 Turn off your computer and unplug your computer’s power cord.2 Connect the signal cable to the VGA and/or DVI-D (optional) and/orHDMI input socket of the monitor, and the VGA and/or DVI-D (optional)and/or HDMI output socket of the graphics card on the computer.or connect MHL cable(Only for MHL-Input Model)(Optional) to theportable device.Then tighten the thumbscrews on the signal cableconnector.3 Connect one end of the adapter to the monitor and the other end to aproperly grounded, AC outlet.4 Plug the power cords of your computer and your monitor into a nearbyelectrical outlet.5 Connect the audio cable.Connect an audio cable to the audio port of the monitor.Panel controlsNo. Item Description1 Power button/indicatorTurns the monitor on/off. Blue indicates poweron. Blinking blue indicates standby/power savingmode.2 < / > button Press the < / > button to navigate to the desiredfunction or to change the settings of the currentfunction.3 Menu/EnterbuttonPress to view the OSD menu. Press it again toenter a selection in the OSD menu.4 Auto/Exit button • When the OSD menu is active, press thisbutton to exit the OSD menu.• When the OSD menu is inactive, pressthis button to activate the Auto Adjustmentfunction.5 EmpoweringKeyPress this button to open the Acer eColorManagement OSD and access the scenario modes.Note: MHL input only works for the MHL-certified device. Please chekuser manual for more instruction.VGA INDVI-INHDMI AUDIO INDVIHDMIVGAAUDIO INVGADVIHDMI DC INHDMI HDMI12345