Acer H277HK Quick Start Manual
Also see for H277HK: User guide
EnglishAcer LCD Monitor Quick Start Guide (QSG)Important safety instructionsPlease read the following instructions carefully.1 To clean the LCD monitor screen:• Turn off the LCD monitor and unplug the power cord.• Spray a non-solvent cleaning solution onto a rag and clean the screen gently.2 Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage it.3 Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.4 Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing of any nature.5 Store the LCD monitor in a room with a temperature of -20° to 60° C (-4° to140° F). Storing the LCD monitor outside this range mayresult in permanent damage.6 Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:• Monitor-to-PC signal cable is frayed or damaged.• Liquid spills onto the LCD monitor or the monitor is exposed to rain.• The LCD monitor or case is damaged.Package contentsLCDmonitorQuickstartguideACAdapterAC PowercordHDMIcable(Optional)DVI / DVI(Dual Link)cable(Optional)Mini DPcable(Optional)Audiocable(Optional)DP cable(Optional)Adjusting the monitor base1 Carefully remove the monitor from its packaging.• The monitor base is attached onto the monitor before shipment and it is undetachable.2 Pull the monitor base out fully so that the monitor can be placed on a stable surface in the upright position.3 Secure the monitor base by turning the white screws (at the bottom of the base) using the integrated tab or a suitable coin.Connecting your monitor to a computer1 Turn off your computer and unplug your computer’s power cord.2 Connect the signal cable to the DVI-D (optional) and/or HDMI (optional) and/orDP (optional) and/or mini DP (optional) input socket of the monitor, and the DVI-D(optional) and/or HDMI (optional) and/or DP (optional) and/or mini DP (optional)output socket of the graphics card on the computer.Then tighten the thumbscrewson the signal cable connector.3 Connect one end of the adapter to the monitor and the other end to a properlygrounded, AC outlet.4 Plug the power cords of your computer and your monitor into a nearby electrical outlet.5 Connect the audio cable (Optional).Connect an audio cable to the audio port of the monitor.Panel controlsNo. Item Description1 Power button/indicatorTurns the monitor on/off. Blue indicates power on.Blinking blue indicates standby/power saving mode.2 < / > button Press the < / > button to navigate to the desiredfunction or to change the settings of the currentfunction.3 Menu/EnterbuttonPress to view the OSD menu. Press it again to enter aselection in the OSD menu.4 Auto/Exit button • When the OSD menu is active, press this button toexit the OSD menu.• When the OSD menu is inactive, press this button toactivate the Auto Adjustment function.5 EmpoweringKeyPress this button to open the Acer eColor ManagementOSD and access the scenario modes.FreeSync:It can allow a FreeSync supported graphics source to dynamically adjust display refresh rate based on typical content frame rates forpower efficient, virtually stutter free and low-latency display update.DP Mini-DPDVI-IN HDMI DC INHDMIDVI-INMini-DPDPAUDIO INHDMIHDMINote: Audio output is only for audio output model. Please check usermanual for more instruction.12345 |
Related manuals for Acer H277HK
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine