Achim Home Furnishings LUG230WH04 Installation Instructions Manual
 |
Installation InstructionsoSTEP 1. Attach the BracketsTo install the end brackets, first determine where toattach each bracket. Ifyou are installing an out-side-mount blind on a window (Fig.A), position thebracket on the window frame or on the wall abovethe frame and attach with the proper fasteners. If in-stalling outside-mount blind on a door (Fig.B), posi-tion the bracket and the spacer block on the doorabove the glass panel and attach with screws.Thespacer block must be between the door and thebracket. If installing inside-mount blind (Fig C),posi-tion top of bracket against inside surface of windowframe and attach as shown. Each end bracket uses atleast two screws. Make sure end brackets are level.Forthe blinds over 48" wide, a center support Exacketwill be provided. To install the support brackets (Fig.D) center the support bracket between the two endbrackets. Keep the top and back of each supportbracket level and aligned with the top and back ofthe end brackets.To Tilt The Blind.If more than one support bracket is used spacethe support brackets evenly across the width ofthe headrail. Insert screws in the top for an insidemount; insert screws in the back for an outsidemount (Fig.DlSTEP 2. Install the HeadrailPosition one valance dip at each end of the head-rail, and evenly space any additional clips acrossthe width of the headrail (Fig.E). Slide the headrailinto the er%ibrackets and center support (fig. F).Then close end bracket covers until they click intoSTEP 3. Install ValanceYour blmd includes a valance (a slat put thevalance under the upper damp of each dip. Thenguide the entire valance into the bottom damps.OPERATING INSTRUCTIONSOSTEP4. Attach Hold-Down &ackets (For Door only)To install the hold-down brackets, lower the blind all theway down. Position bracket dose enough to the bottomrail so that the hold-down pin lines up with the hole andthe hold-down bracket (Fig.H). Attach the hold-downbrackets with screws. Insert the pins into the center Ofeach side of the bottom rail.• Rotate the wand in either direction to fully open and close the slats to the desired angle.To Lower and Raise The Blind:• Tilt the slats to the fully open position first. (Parallel with headrail).• Grasp bottomrail firmly on both side evenly. and pull down gently until reaching the desired length.• To raise the blind, simply grasp both side of the bottomrail and raise slowly to desired position.Trouble Shooting:Problem: Uneven Bottomrail• Pull the blind down evenly on both side and adjust both side when raising the blind up again. |
Related manuals for Achim Home Furnishings LUG229WH04
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine