HEAT PUMPAIR / WATERWITH REGULATIONACOND® THERMOPERATING MANUALSoftware version 140.1 and 140.2In short:To turn the heat pump on / off:• If the symbol is on the display and the room temperature is notdisplayed, the heat pump is switched off.• Press and hold the rotary button on the room unit for about 7s. The heat pump isswitched on, the display shows the room temperature.• When the heat pump is switched on, pressing and holding the rotary button (7s)switches the heat pump off.To set the room temperature:• Press the rotary button.• The desired indoor temperature flashes on the display.• Turn the button to the right to increase the desired room temperature by 0.5 °C, turnthe button to the left to decrease it.• Press the rotary button again and the display will display the room temperatureagain.• For more information, see chapter 3.1.5 on page 15.To determine the outdoor temperature:• Turn the button to the right and the outdoor temperature will be displayed for 5s.To determine the temperature of service water (TUV):• Turn the button to the left and the water temperature (if fitted) will be displayed for5s.

Acond PRO-N Operating Manual