Acoustic Research PW100 User Manual
        |
Indicator Lights• “Protected” indicator-The prconditioner should be on whthis indicator goes out andpower conditioner has sacriand should be replaced.• “Grounded” indicator-The grconditioner should be on whthe light does not come ona ground wiring problem maelectrician to properly grounpower conditioner tooutlet will void all Tho• “Volts” indicator (available otells you the number of voltsthe power conditioner into.Power Conditionerwith Surge SuppressionUSER GUIDE for PW100/101Power ConnectionsCoax Cable ConnectioPhone/Fax/ModemConnecting Equipment To YourAcoustic Research Power Conditionerwith Surge Suppression1. Plug the power conditioner into a grounded outlet.2. Plug all connected equipment directly into the power conditioner.Note: Power plugs can be heavy and may cause the conditionerto tip backwards slightly. If this happens, pull out the extendingarm on the left size of the conditioner’s back panel. This armstabilizes the unit.3. Turn on the power conditioner. The LED will illuminate when the unit ispowered on. Your power conditioner provides maximum surgeprotection even if the power switch is in the off position.1. Connect thePhone/Fax/Modem line fromyour wall outlet tothe INPUT jack onthe powerconditioner.2. Connect a secondphone cord intothe OUTPUT jackon the powerconditioner.Pass the phone/fax/modem connconditioner as illustrated.Pass the coaxial cable connecon your power conditioner. Mcan be prevented if you conneconditioner.21. Connect theCable/Antenna linefrom your sourceto the INPUT jackon the powerconditioner.2. Connect the coaxcable from theOUTPUT jack ofthe powerconditioner to thedevice you want toprotect.1GROUNDEDOUTLETRECEIVERTVVCRDVDAUDIO EQUIPMENT22222CAUTION!DO NOT connect to an ungrounded outlet. DO NOT use with2-wire extension cords or adapters. This power conditioner is designedfor indoor use only. Install the power conditioner away from heatemitting appliances such as radiators or heat registers. Do not installwhere excessive moisture is present. Do not plug extension cords intothe power conditioner. Never install electrical or telephone wiring duringa lightning storm. DO NOT USE FOR MEDICAL OR OTHERLIFE SUPPORT EQUIPMENT OR OTHER HIGH RISKACTIVITIES. DO NOT USE IN DAMP AREAS OR NEARWATER RELATED APPLICATIONS SUCH ASAQUARIUMS, HOT TUBS, ETC.3. Connect the other end of thePhone/Fax/Modem jack of the |
manualsdatabase
Your AI-powered manual search engine