CARTRIDGESInstruction ManualMounting the MM cartridgeRemove stylus unit with stylus guard beforeworking with leads and screws. Handle allparts carefully. (fig. 1-2)Note colours and channel indications onrear side of the body for correct connectionof the tone arm leads. (fig. 3)The packing contains a pair of screws with athread length of 5 mm. The screws are to beused with headshell thicknesses of max.3.5 mm. The MM threaded mounting platehas a thickness of 3 mm.To check that you are using the right lengthof screws – please observe that screwsmust not touch the body under the mountingplate – look into the small openings on eachside of the body. (fig. 4)Do not tighten screws completely before thestylus unit has been remounted (fig. 1) – toadjust stylus overhang refer to the recordplayer or tone arm manual and cartridge di-mensions. (fig. 5)Never overtighten screws and never usealuminium screws, as they can get stuck inthe threaded holes of the mounting plate.Note: If excessively long screws are usedand are pressing against the body material,this may influence channel separation andcould damage the cartridge body. In case ofsuch damage the warranty will be void.