ActionTec MegaPlug HPE400T Quick Start Manual
Also see for MegaPlug HPE400T: User manualSpecifications
  | |
Contents | 
Note: You do not need to complete this section if you connected the Hub to adevice other than a Computer. This utility can be used to adjust the securitysettings of the Hub. For more information, see the User Manual which is located onthe Installation CD-ROM.Note: An Ethernet port looks similar to a phone port but is slightly larger.A Connect the Hub to a DeviceB Install the Configuration UtilityStep1 Get the MegaPlug85 Mbps 4-Port Hub from theQuick Start Kit.Step4 Plug the other end of theEthernet Cable into an OPENEthernet Port on your computeror other device.Step7 Plug the other end into aPower Outlet.Do NOT plug the Hub into a powerstrip or wall outlet that uses surgeprotection as the Hub may not work.Step1 Get the Installation CDand insert it in the computer’sCD-ROM Drive.Flip this Quick Start Guide over to continue NEXTStep2 Get the Gray EthernetCable.Step3 Plug one end of theEthernet Cable into any openEthernet Port on the back of theMegaPlug 4-Port Hub.Step5 Get the Power Cordfrom the Quick Start Kit.Step6 Plug one end into the ACIn Port located on the back of theMegaPlug 4-Port Hub.Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA)!NOTE: This device requires another HomePlug (MegaPlug) compatibledevice connected to your modem or router in order to function. If youdo not have another HomePlug compatible device, you may order oneby visiting www.actiontecstore.com/homeplug |
Related manuals for ActionTec MegaPlug HPE400T
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine