Addonics Technologies ADIDESA Installation Manual

ADDONICS TECHNOLOGIESModel: ADIDESAInstallation GuideFront ViewBack ViewNote: It is required to set up the IDE hard drive you areconnecting to the converter as a MASTER device.1. Locate the 40-pin IDE connector of your IDE drive.2. Connect the converter board to the IDE connector of thehard drive.3. Using the provided Y-power cable, connect the 4-pinMolex connector to the power connector on the harddrive. This will provide power to the hard drive.4. At the other end of the Y-power cable is the 4-pin floppypower connector which you connect to the converter.Now connect the SATA cable to the SATA port on theconverter and the other end connect it to an onboardSATA port or an add-in SATA card.TECHNICAL SUPPORTAddonics Technologies Phone: 408 433-38992466 Kruse Drive Fax: 408 433-3898San Jose CA 95131Email: http://www.addonics.com/sales/query/Internet: http://www.addonics.comTechnical Support (8:30 am to 6:00 pm PST)Phone: 408 433-3855Email: http://www.addonics.com/support/query/SATA Port4-Pin FloppyPower Connector40-pin IDE ConnectorIDE Connector4-pin MolexPower ConnectorMaster or SlaveJumper Settings

/ 1

Related manuals for Addonics Technologies ADIDESA